Filter
Top Products
8
9
English
Using the CR-389 remote control
FM DAB
PROG DISP
RPT
MODE BAND
1–9 2–10 3–11
FM
DAB
SEL
TUNER
CR-389
CD
AMPLIFIER
VCRDVD TAPEAV
TUNERCDAU
XPHONO
ENTER
SP1
SP2
DISP
MENU DISP
4–12
5–13 6–14 7–15 8–16
FM/DAB
Ensure that the FM mode is selected using the
FM/DAB toggle button. The FM LED above the FM/
DAB button is lit briefly when FM is selected.
Preset memory buttons
These buttons allow access to individual preset stations. To
select a preset press the corresponding keypad button. For
presets 9–16, press and hold the corresponding preset button
for one second. Use the Tune buttons to access FM memory
presets 17 to 30.
NOTE: Remember to install the two AAA batteries
supplied before trying to use your remote control.
Do not place anything in front of the display area on
the tuner (where the IR receiver is located), or the
remote control may not work.
Tune buttons
These buttons enable you to scroll through the stored
station selections one at a time, or to tune up or down,
depending on the Tuning mode.
BAND
This button toggles between FM and AM.
MODE (Tuning mode)
This button toggles between
PRESET and TUNE modes.
Amplifier controls
These buttons offer basic control over Arcam amplifiers,
such as the FMJ A32.
CD player controls
These buttons offer basic control over Arcam CD players,
such as the FMJ CD23.
MENU (RDS mode)
This button scrolls through RDS modes, when available.
DISP (Display)
This button allows you to dim or switch off the tuner display.
STANDBY
This button switches the tuner (and the amplifier if
appropriate) between ‘On’ and ‘Standby’. This function
does not apply Arcam CD players.
NOTE: DAB (Digital Audio Broadcast) refers to
Arcam DAB tuners such as model DT81.