Filter
Top Products
8-EN
01GB04CDE121.fm
ALPINE CDE-121 68-16909Z79-A (EN)
Setting Time
1
Press SETUP to activate the SETUP mode.
2
Turn the Rotary encoder to select the
CLOCK ADJ mode, and then press the
Rotary encoder or / /ENT.
The time indication will blink.
3
Turn the Rotary encoder to adjust the hours
while the time indication is blinking.
4
When the hour has been adjusted, press the
Rotary encoder or / /ENT.
5
Turn the Rotary encoder to adjust the
minutes while the time indication is blinking.
6
Press SETUP to return to normal mode.
• To synchronize the clock to another clock/watch or radio
time announcement, press and hold the Rotary encoder
or //ENT for at least 2 seconds after setting the
“hour”. Minutes will reset to “00”. If the display shows
over “30” minutes when you do this, the time will
advance one hour.
• Pressing /MUTE will return to the previous mode.
• If no operation is performed for 60 seconds, the unit will
return to normal mode automatically.
Listening to Radio
1
Press SOURCE/ to select TUNER mode.
2
Press BAND repeatedly until the desired
radio band is displayed.
F1 (FM1) F2 (FM2) AM F1 (FM1)
3
Press TUNE/A.ME to select the tuning mode.
SEEK DX (Distance mode) SEEK LO (Local mode)
MANUAL (Manual mode) SEEK DX
• The initial mode is Distance mode.
Distance mode:
Both strong and weak stations will be automatically
tuned in (Automatic Seek Tuning).
Local mode:
Only strong stations will be automatically tuned in
(Automatic Seek Tuning).
Manual mode:
The frequency is manually tuned in steps (Manual
tuning).
4
Press or to tune in the desired
station.
Holding down or will change the frequency
continuously.
Controllable with Remote Control
This unit can be controlled with an optional Alpine
remote control. For details, consult your Alpine dealer.
Point the optional remote control transmitter at the
remote-control sensor.
Remote control sensor
Radio
BAND
TUNE/A.ME
Preset buttons
(1 through 6)
SOURCE/
Rotary encoder
/ESC
/MUTE
01GB00CDE121.book Page 8 Monday, December 13, 2010 2:03 PM