Alpine CDA-9856 Car Stereo System User Manual


 
6-EN
Turning Power On and Off
Press SOURCE/POWER to turn on the unit.
The unit can be turned on by pressing any other button except TITLE,
Rotary encoder and (OPEN).
Press and hold SOURCE/POWER for at least 2 seconds
to turn off the unit.
The first time power is turned on, the volume will start from level 12.
Detaching and Attaching the Front Panel
Be sure to push the Rotary encoder inside the unit before opening the
front panel so that the front panel will open completely, otherwise it
may be damaged.
When you push the Rotary encoder again, it pops back out.
Detaching
1
Turn off the unit power.
2
Press (OPEN) to open the front panel.
To close the front panel, press the left side until it locks as
shown in the figure below.
3
Grasp the front panel firmly, slide to the left ,
then pull to remove.
The front panel may become hot in normal usage (especially the
connector terminals on the back of the front panel.) This is not a
malfunction.
To protect the front panel, place it in the supplied carrying case.
When detaching the front panel, do not apply excessive force as it
may result in malfunction.
Do not leave the front panel open, or drive the car with the panel
open as it may result in accident or malfunction.
Attaching
1
Insert the right side of the front panel into the main
unit. Align the groove on the front panel with the
projections on the main unit.
2
Push the left side of the front panel until it locks
firmly into the main unit.
Before attaching the front panel, make sure that there is no dirt or
dust on the connector terminals and no foreign object between the
front panel and the main unit.
Attach the front panel carefully, holding the sides of the front panel to
avoid pushing buttons by mistake.
Getting Started
About the alphanumeric display of this unit
All English lower case characters are displayed as upper case on
this unit.
The alphanumeric display in the following table shows
alphanumeric characters/numbers that may be difficult to
distinguish.
SOURCE/POWER
Rotary
encoder
MUTE
(OPEN)
MODE TITLE
Alphanumeric
Display
Alphanumeric
Display
Push the Rotary
encoder inside
The Rotary
encoder pops out