Alpine CDA-7863 Car Stereo System User Manual


 
5-EN
Movable display
The movable display may be adjusted to 3
different angles depending upon user preference.
1 Press the ANGLE 8 or 9 button to adjust the
angle of the movable display.
NOTES
The display will close a half minute after the ignition
key is turned to the OFF position.
The adjusted angle of the display is stored in memory.
There is no need to re-adjust the angle when the power
is turned back on.
CAUTION
Keep hands (or any other object) away from the display
while it is opening or closing to avoid damage or injury.
The back of the movable display will get very warm
under normal operating conditions. This is not a
malfunction. Do not touch.
Adjusting Volume/Bass/Treble/
Balance (Between Left and Right)/
Fader (Between Front and Rear)
1 Press the MODE (Audio Control) knob
repeatedly to choose the desired mode.
Each press changes the modes as follows:
NOTES
If the MODE (Audio Control) knob is not rotated in 5
seconds after selecting the BASS, TREBLE,
BALANCE, or FADER mode, the unit automatically
returns to the VOLUME mode.
When the subwoofer or BBE mode is ON, their
respective levels may be adjusted.
2 Rotate the MODE (Audio Control) knob until the
desired sound is obtained in each mode.
NOTES
The settings of the Bass and Treble will be individually
memorized for each source (FM, AM and CD) until the
setting is changed. Depending on the connected
devices, some functions and display indications do not
work.
When the temperature inside the unit rises, the volume
may decrease momentarily. This is not a malfunction.
Display Angle Adjustment
VOL BAS TRE
FAD BAL
Turning Loudness On/Off
Loudness introduces a special low- and high-
frequency emphasis at low listening levels. This
compensates for the ear's decreased sensitivity to
bass and treble sound.
1