Alpine CDA-9812RB Car Stereo System User Manual


 
6-EN
Getting Started
Turning Power On and Off
Press SOURCE/POWER to turn on the unit.
The unit can be turned on by pressing any other button except eject
c.
The volume level gradually increases to the previous level you
were listening to before the unit was turned off.
Press and hold SOURCE/POWER for at least 3
seconds to turn off the unit.
The first time power is turned on, the volume will start from level 12.
Initial System Start-Up
Be sure to press the RESET switch when using the unit for the first
time, after installing the CD changer, after changing the car battery, etc.
1
Turn off the unit power.
2
Press RESET with a ball-point pen or similar
pointed object.
Opening and Closing the Movable Display
Press c.
The movable display will open.
To close the movable display, press c again.
The movable display will close.
Do not apply shock to the movable display when it is open as it
may result in malfunction of the unit.
The display may be dim during low temperatures and immediately
after turning on the power. The brightness will return to normal as
time elapses.
The display will stop at the set tilt angle when closing.
Caution
Keep hands (or any other object) away from the display while it is
opening or closing to avoid damage or injury. The back of the
movable display will get very warm under normal operating
conditions. This is not a malfunction. Do not touch.
SOURCE/
POWER
DISP/B.OUT (CDA-9815RB/CDA-9813R/
CDA-9812RX)
MUTE/B.OUT (CDA-9811R)
Display Tilt Adjustment
The movable display may be adjusted to 3 different tilt angles
depending upon user preference.
Press TILT 98 to adjust the tilt angle of the movable
display.
The display will close a half minute after the ignition key is turned
to the OFF position.
The adjusted tilt angle of the display is stored in memory. There is
no need to re-adjust the tilt angle when the power is turned back on
.
Caution
Keep hands (or any other object) away from the display while it is
opening or closing to avoid damage or injury. The back of the
movable display will get very warm under normal operating
conditions. This is not a malfunction. Do not touch.
Adjusting Volume
Turn the Rotary encoder until the desired sound is
obtained.
Lowering Volume Quickly (CDA-9811R only)
Activating the Audio Mute function will instantly lower the volume
level by 20 dB.
Press MUTE/B.OUT to activate the MUTE mode.
The audio level will decrease by about 20 dB.
Pressing MUTE/B.OUT again will bring the audio back
to its previous level.
TILT 98
Rotary encoder c
RESET
Movable display