Filter
Top Products
22-EN
Calling
The lists for Speed Dial, Phone Book, outgoing
history, incoming history and incoming missed call
history can be displayed. You can place a call by
these lists.
Calling by using the Speed Dial
You can place a call by retrieving one of the
telephone numbers registered in No. 1 to 9 of the
address book.
1 Press and hold BAND/TEL. for at least 2
seconds to display “SPEED DIAL.”
2 Press and hold (for at least 2 seconds) a preset
button (1 through 6) to place a call.
By pressing FUNC, and then pressing a preset
button (1 through 3) for at least 2 seconds, you
can place a call to the number registered in 7 to
9.
NOTE
You can place a call by pressing -/J after momentarily
pressing the preset button (1 through 6) of the number
you wish to call.
3 Press and hold BAND/TEL. for at least 2
seconds to end the call.
The telephone mode will end and return to the
original source mode.
Calling by the Phone book
You can call up the Phone book registered in the
portable telephone to call from.
1 Press and hold BAND/TEL. for at least 2
seconds.
2 Press BAND/TEL. to select "PHONE BOOK" (on
the monitor) or "PHONE Bk"(on the sub-display).
The names in the phone book are displayed in
alphabetical order.
3 Press g or f to select the addressee from
the phone book.
To skip alphabetically to the next (or previous)
set of name, press and hold g or f for at
least 2 seconds.
4 Press :/J to place a call when the monitor is
closed.
Or press :/J twice when the monitor is open. At
the first press, the name and telephone number
of the addressee is displayed. Then the second
press places the call.
5 Press and hold BAND/TEL. for at least 2
seconds to end the call.
The telephone mode is canceled and returns to
the original source mode.
Calling by the outgoing history
You can place a call to any of the last 999 dialed
calls recorded in memory.
1 Press and hold BAND/TEL. for at least 2
seconds.
2 Press BAND/TEL. again repeatedly to select
"DIALED."
3 Press g or f to select an addressee from
the outgoing history.
Press and hold g or f to change the
addressee continuously.
4 Press :/J to place a call when the monitor is
closed.
Or press :/J twice when the monitor is open. At
the first press, the name and telephone number
of the addressee is displayed. Then the second
press places the call.
5 Press and hold BAND/TEL. for at least 2
seconds to end the call.
The telephone mode will end and return to the
original source mode.
NOTE
You cannot use this function if there is not an outgoing history on
the unit.
MobileHub™ Link Operation
(
Optional
)
BAND/TEL.
gg
gg
g
ff
ff
f preset buttons
(1 through 6)
::
::
:/
JJ
JJ
J FUNC
MUTE/SETUP
Preset 6