Filter
Top Products
23-EN
SMS (Short Message Service)
Operation
You can receive short messages and display the
contents.
1 All received messages are indicated by an icon
(on the monitor) or “NEW MSG” (on the sub-
display).
When the monitor is open, press and hold
BAND/TEL. for at least 2 seconds.
2 Press BAND/TEL. again repeatedly until "SMS
INBOX" is indicated and the list of received
message is displayed.
3 Press g or f to select a message and then
press -/J to display the message content.
Press -/J again to return to the list.
4 Press and hold BAND/TEL. for at least 2
seconds to return to the original source mode.
Setting the Call Receiving Method
Connecting to the Junction Box is necessary to
set the call receiving method.
After carrying out steps 1 to 3 of “To display the
SETUP screen” (page 29), perform the operation
shown below.
1 When the monitor is open, press and hold
MUTE/SETUP for at least 2 seconds. The
SETUP screen appears.
2 Press preset 6 to activate the OTHER setting
mode. Press preset 6 again to select TEL
RECEIVE.
3 Press g or f to select AUTO or MANUAL.
AUTO:
The incoming call is automatically accepted
after 3 seconds.
MANUAL:
The incoming call is manually accepted by
pressing -/J.
For any other settings, press preset 6 or another
preset button.
4 After setting is completed, press MUTE/SETUP
to return to normal mode.
MobileHub™ Link Operation
(
Optional
)
Calling by the incoming history
You can place a call to any of the last 999
received calls recorded in memory.
1 Press and hold BAND/TEL. for at least 2
seconds.
2 Press BAND/TEL. again repeatedly to select
"RECEIVED."
3 Press g or f to select an addressee from
the incoming history.
Press and hold g or f to change the
addressee continuously.
4 Press :/J to place a call when the monitor is
closed.
Or press :/J twice when the monitor is open. At
the first press, the name and telephone number
of the addressee is displayed. Then the second
press places the call.
5 Press and hold BAND/TEL. for at least 2
seconds to end the call.
The telephone mode will end and return to the
original source mode.
NOTE
You cannot use this function if there is not an incoming
history on the unit.
Calling by the incoming missed call history
1 Press and hold BAND/TEL. for at least 2
seconds.
2 Press BAND/TEL. again repeatedly to select
"MISSED."
3 Press g or f to select an addressee from
the absent incoming history.
Press and hold g or f to change the
addressee continuously.
4 Press :/J to place a call when the monitor is
closed.
Or press :/J twice when the monitor is open. At
the first press, the name and telephone number
of the addressee is displayed. Then the second
press places the call.
5 Press and hold BAND/TEL. for at least 2
seconds to end the call.
The telephone mode will end and return to the
original source mode.
NOTE
You cannot use this function if there is not an incoming
missed call history on the unit.