Alpine CVA-1004 Car Video System User Manual


 
25-EN
Other Useful Features
2
If an MP3 file contains ID3 tag information, all the
ID3 tag information is displayed (e.g., track name,
artist name, or album name). All other tag data is
ignored.
“NO TAG” will be displayed if an MP3 file contains
no ID3 tag information.
3
The recording sampling rate and bit rate of the MP3
file are displayed.
NOTES
Some characters may not be displayed correctly with
this device, depending on the character type.
The CD changer must also be CD Text compatible for
the Text information to be displayed.
When the Scroll Setting (refer to page 31) is set to
“MANUAL”, press and hold TITLE
for at least 2
seconds to scroll the Text information, etc., only once.
"NO SUPPORT" is displayed when the desired text
information cannot be displayed on this unit.
If the title was not previously input, the monitor
display will be blank or the sub-monitor will display
_ _ _ _ _ _ _ _
.”
Titling Discs/Stations
It is possible to title your favorite discs or radio
stations.
To activate the Title display mode:
To title a disc, your vehicle must be parked with the
ignition key in the ACC or ON position. To do this, follow
the procedure below.
1. Push the foot brake to bring your vehicle to a
complete stop at a safe location. Engage the parking
brake.
2. Keep pushing the foot brake and release the parking
brake once then engage it again.
3. While the parking brake is being engaged the
second time, release the foot brake.
NOTE
For automatic transmission vehicles, place the transmission
lever in the Park position.
Now, the locking system for the Title display mode has
been released. Unless the ignition key is turned OFF,
the Title display mode can be activated by engaging
only the parking brake. The steps above (1 through 3)
are not necessary. Each time the ignition key is turned
OFF, the above steps must be repeated.
NOTE
You cannot title discs/stations while you are driving. If you
attempt to drive while titling, the display will show the
warning “CAN’T OPERATE WHILE DRIVING” for 5
seconds and then the unit will return to normal mode.
1 When the monitor is open, press TITLE and
select the title display mode.
For details, see “Displaying the Title/Text” (page
24).
2 Press and hold the TITLE for at least 2
seconds. The first character will blink.
3 Press g or f to select the desired letter/
numeral/symbol available for naming.
4 Press -/J to store the first character. The first
character will stop blinking and the display will
automatically advance to the next character.
When that character begins to blink, you may
choose the next letter or symbol of your title.
5 Repeat the steps 3 and 4 above to complete the
titling. Pressing -/J after entering the 8th
character, automatically stores the title into
memory.
When entering a title of less than 8 characters
(for example, 3 character title):
After entering 3 characters to complete your title,
the 4th character space will be blinking. Go to
step 6 to complete the title.
6 Press TITLE to record the title.
NOTES
If you cancel while entering a title, selected characters
are not written.
You can enter 24 radio station titles on this unit. If you
try to store beyond the limit, the display will show
“MEMORY FULL” At this point, no more titles can be
stored.
The Changer memory capacity varies depending upon
the model being used.
To input a new title, one of the previously inputted
titles must first be deleted.
When you want to erase a title, enter a space into all
spaces.
The operations described in steps 3 to 5 must be made
within 10 seconds. The input mode will be canceled if
no action is taken for over 10 seconds.
Removing power from the unit may delete station
titles. Use caution when manipulating the power cord.