Alpine CVA-1004 Car Video System User Manual


 
29-EN
Illumination Control
To display the SETUP screen:
To display the Setup screen, your vehicle must be
parked with the ignition key in the ACC or ON
position. To do this, follow the procedure below.
1. Push the foot brake to bring your vehicle to a
complete stop at a safe location. Engage the
parking brake.
2. Keep pushing the foot brake and release the
parking brake once then engage it again.
3. While the parking brake is being engaged the
second time, release the foot brake.
NOTE
For automatic transmission vehicles, place the
transmission lever in the Park position.
Now, the locking system for the SETUP screen
operation has been released. Unless the ignition
key is turned OFF, the SETUP screen can be
activated by engaging only the parking brake. The
steps above (1 through 3) are not necessary.
Each time the ignition key is turned OFF, the
above steps must be repeated.
1 When the monitor is open, press and hold
MUTE/SETUP for at least 2 seconds. The
SETUP screen appears.
2 Press preset 1 to activate the DISPLAY setting
mode. Press preset 1 again to select DIMMER.
3 Press g or f to set the Illumination control.
AUTO: In the Auto Dimmer mode, the
backlighting of the monitor is dimmed
when the instrument panel lighting of the
vehicle is turned on (the dimmer input
lead must be connected.)
ON: Deactivate the Auto Dimmer mode and
keep the backlighting low.
OFF: Keep the backlighting of the monitor
bright.
For any other settings, press preset 1 or another
preset button.
4 After setting is completed, press MUTE/SETUP
to return to normal mode.
Adjusting Brightness of Picture
After carrying out steps 1 to 3 of "To display the
SETUP screen" (described on this page), perform
the operation shown below.
1 When the monitor is open, press and hold
MUTE/SETUP for at least 2 seconds. The
SETUP screen appears.
2 Press preset 1 to activate the DISPLAY setting
mode. Press preset 1 again to select BRIGHT.
3 Press g or f to make the picture darker or
brighter. You can adjust the brightness between
MIN (16) and MAX (+16). When it reaches the
minimum or maximum point, the display shows
"MIN" or "MAX" respectively.
For any other settings, press preset 1 or another
preset button.
4 After setting is completed, press MUTE/SETUP
to return to normal mode.
NOTE
The Brightness settings for the video sources (AUX/DVD/
NAV.) will be individually memorized.
Other Useful Features