Filter
Top Products
16
4
The mid frequency driver cover plate
should easily lift right off of the horn.
Holding down the horn assembly
with one hand while lifting up on the
cover plate with the other hand may
help. The positive (solid green) and
negative (green and black) cables
are still attached to the mid frequency
driver cover plate terminals. Remove
the cables from the terminals simply by
pulling on the end of each cable. Do not
force cable removal, although needle-
nose pliers may aid in tightly crimped
cables.
Mid Frequency Driver replacement continued:
-
+
Pull out
Pull out
-
+
5
Four screws and locking washers may
be removed from the mid frequency
driver using the phillips head screwdriver.
Contrary to what the picture shows, the
screws are actually about 2
3/4
” down
from the top of the horn assembly. Also
note that the screws may be tighter than
usual. Please DO NOT add WD-40 or any
other lubricant to help loosen the screws.
1
2
3
4
-
+
1
2
3
4
-
+