ASA Electronics JHD3000 Car Stereo System User Manual


 
JHD3000 Troubleshooting Guide
Radio will not turn ON
Check fuse.
Confirm 12V+ on battery wire to radio (YELLOW wire).
Confirm 12V+ on accessory wire to radio (RED wire).
Confirm Ground.
Radio turns ON, but no sound
Verify Volume¸ Fader/Balance¸ Mute controls are set correctly (see owners
manual).
Verify proper speaker connections.
Check for shorts or opens on speaker wires.
CD does not load fully
Make sure unit has power and no other CD is currently inside.
CD does not play correctly
Check to make sure disc is inserted correctly.
Verify disc is free from dirt, scratches, etc.
Check with factory CDs.
Check factory original CDs for compatibility warnings (due to various copy-
protection, multi-media content, etc).
Disc skips during playback – verify you have not exceeded 30 degrees mounting
angle.
No AM or FM reception
Verify you are tuned to a valid station.
Check your antenna connection on rear of stereo.
Try a different antenna.
Unit loses memory during engine crank with diesel motor
Engine crank is dropping voltage to the Yellow 12VDC+ power wire below
operating threshold. Stabilize voltage from vehicle.
No sound in PA mode
Make sure microphone is connected to PA MIC input.
Make sure microphone volume is turned up.
Make sure you are using a compatible microphone and adaptor(s) provided by
ASA (Voyager or Jensen branded microphone only).
B. Woods
Tech Services
05.15.07