Filter
Top Products
1111
1111
11
OPEROPER
OPEROPER
OPER
AA
AA
A
TT
TT
T
ING INSTRUCING INSTRUC
ING INSTRUCING INSTRUC
ING INSTRUC
TT
TT
T
IONS / SETIONS / SET
IONS / SETIONS / SET
IONS / SET
TT
TT
T
ING THE CLOCK / ERRING THE CLOCK / ERR
ING THE CLOCK / ERRING THE CLOCK / ERR
ING THE CLOCK / ERR
OR CODESOR CODES
OR CODESOR CODES
OR CODES
CD PLCD PL
CD PLCD PL
CD PL
AA
AA
A
YER ERRYER ERR
YER ERRYER ERR
YER ERR
OR CODESOR CODES
OR CODESOR CODES
OR CODES
1. Switch the vehicle ignition and radio “on”.
2. Press the Time/Frequency (T/F) button to call the time display.
3. While holding the T/F button in, press the Down TUNE/SEEK/TRACK ( ) button
to adjust the hours and AM/PM indication, or the Up TUNE/SEEK/TRACK ( )
button to adjust the minutes to the correct time.
4. Five seconds after the last hour or minute adjustment is made, the time will be set in
the unit and the display will return to the normal indication.
If a problem should develop while operating the CD player, an error code (ER-1, ER-2,
ER-3, etc.) may appear on the display panel. This can indicate a number of problems
with the unit, including a mechanical error or an error in the microprocessor control of the
player. If an error code should appear, try ejecting and re-loading the disc into the player.
While the disc is out of the unit, make sure it is clean, undamaged, and loaded correctly
(label surface up). You may also try activating the RESET button cu on the unit, but this
will also erase the time and pre-set memories.
If the suggested measures do not solve the problem, contact an approved warranty
station near you for further assistance.
SETSET
SETSET
SET
TT
TT
T
ING THE CLOCKING THE CLOCK
ING THE CLOCKING THE CLOCK
ING THE CLOCK
+
-
MOTORIZED FOLD-DOWN
FRONT PANEL
DISC SLOT
THEFT-DETERRENT
LED AND RESET BUTTON
(BEHIND FRONT PANEL)
FRONT PANEL
RELEASE TAB