Audiovox RB3600 Car Stereo System User Manual


 
INSTALLATION AND WIRING INSTRUCTIONS
AMPLIFIER MODULE
Mount the amplifier module in a location that is conveniently accessible to the rear speaker
wiring harness. It is these wires that the RB-3600 interrupts. It is not necessary to mount the
amplifier module close to the television. Connect one end of the 10-pin cable assembly to the
amplifier module (see figure #1 ).
Cut the wires to the rear radio speakers
Connect the rear speaker(s) as follows:
Left rear speaker(s)
Left rear speaker(s)
Right rear speaker(s)
Right rear speaker(s)
:white wire on 4-pin connector
:purple wire on 4 -pin connector
:blue wire on 4-pin connector
:green wire on 4-pin connector
+
+
Connect the dash radio rear amplifier outputs as follows:
Left rear amplifier
Left rear amplifier
Right rear amplifier
Right rear amplifier
+
+
:grey/white wire on S-pin connector
:grey wire on S-pin connector
:brown/white wire on S-pin connector
:brown wire on S-pin connector
Connect 12 'Jolt power to the RB-'3600 as follows:
+12 volt power
Ground
:red wire on S-pin connector
:black wire )n S-pin connector
Connect the Audiovox television external speaker output to the RB-3600 as follows:
External speaker output
External speaker output
+
:pink blue wire on S-pin connector
:black/white blue wire on S-pin connector
Unplug the audio output of the VCP. Connect the isolation transformer as follows:
Isolation transformer male RCA : to VCP audio output
Isolation transformer female RCA : to RCA cable that was plugged into the VCP