Audiovox SW-50 Car Speaker User Manual


  Open as PDF
of 4
 
.fiWt.fie as jt(
I. Remove Plastic Shipping Caps from Generator Components. Assemble Generator Components as
illustrated below, EXCEPT the *STAMPED NUT (5/8-18). See Note I
2. You will need to work where the Vehicle Speedometer Cable is attached to the Transmission. If
necessary. raise the vehicle. Chock Wheels.
,B~not get ~d~,r,~Yvehicle held~p by.ajacko,~~-,Us~Jack Stands or Ramps-,
":l:JI;eweb,9£,,a,~9~c~~teblockWiU ,n9{ car-,,'I)ONOT,RISK,YOUR LIFE! "
" , "'"", ' ,I""", ",I" "" ' " ' " ,
3. A. Disconnect Vehicle Speedometer Cable from Transmission.
B. Connect Speedometer Cable to TANG DRIVE ADAPTER. Seat Speedometer Cable into
TANG DRIVE ADAPTER Slot, tighten Speedometer Cable. See Note .I
c. Install Generator Assembly into transmission housing. Turn SIGNAL GENERATOR so wires
will not catch on objects while driving. Tighten Nut.
TO EXISTING
SPEEDOMETER
CABLE
-
NOTE .I
After Cable is assembled, inserlADApTERKEYintoother
end and rotate Drive Cable. If Cable will not rotate,
remove TANGDRIVEADAP:TER andinsta11*STD NUT
(5/8-18) in position shown. Reinstall TANG])iu\iE ADAPTER.
This will allow clearance betWeen Speedometer Drive
Cable Inner Core Wire and SIGNAL GENERATOR Assembly.
Form# 2097
6199 Rev B
 previous