Boston Acoustics Model 25 Car Speaker User Manual


 
5
WIRELESSID
4321
VOLUME
POWER
MIN
MAX
22
23 24 25 26
230V~
50Hz
0.5A
TVe e
®
Model 25
22 Wireless ID Switch – Selects the “channel” for the wireless subwoofer signal. Set in the same position as 11
(see previous page).
23 Volume – Adjusts the volume of the subwoofer for best balance with the soundbar.
24 Status Indicator – Lights green when the subwoofer is active and red when it is standby mode.
25 Power On/O Switch – Turns the TVee subwoofer on or off. Normally it is left on all the time.
26 Power Cord– Plug it into an AC outlet.
Place Your System
Decide on the location and position of the system before making any connections.
Soundbar Location
Place the soundbar on a table surface or shelf near the
television, or wall-mount the soundbar above or below
the television.
Keyhole mounts on the rear of the
soundbar permit wall mounting.*
Wall-Mounting
The TVee Model 25 soundbar can be wall-mounted using the integrated keyhole mounts. A mounting template can be
found in the inner flap of the product carton. Using a level tool, position and tape the template to the wall in the desired
location. The template is designed to allow enough room for the grille and keyhole mounts when the soundbar is mounted
below a TV.
Install hardware* using the template as a guide and then remove the mounting template from the wall. Connect your audio
and power cables prior to mounting the soundbar on the wall. Place the grille on the soundbar after mounting.
*Consult a person knowledgeable about your wall type to recommend suitable hardware for hanging the speaker. You can
remove the rubber feet before hanging the speaker on the wall. Usually it is best to leave soundbar off the wall until connections
are made.
Set the rear panel LOCATION 12 switch to match how the soundbar is placed. Use WALL
for wall mounting and TABLE for placement on a shelf, cabinet, or table.
LOCATION
TABLE WALL
Subwoofer