Fusion CP-AW2120 Car Amplifier User Manual


  Open as PDF
of 2
 
ACTIVE WEDGE
SPECIFICATIONS
CP-AW1120 CP-AW2120
PeakPower(Watts) 750 900
RatedPower(Watts) 250 300
FrequencyResponse 32Hz-250Hz 32Hz-250Hz
LowPassFilter(Variable) 40Hz-250Hz 40Hz-250Hz
Tuning BassReex BassReex
WooferSize 12” Dual12”
Fuse 25A 30A
Dimensions(mm) 567(l)x415(w)x384(h) 836(l)x415(w)x384(h)
22-5/16x16-11/32x15-3/32” 32-29/32x16-11/32x15-3/32”
CP-AW1120, CP-AW2120
www.fusionelectronics.com
CONTROL DESCRIPTIONS
LEVEL
Thisallowstheadjustmentoftheamplierlevelofthesubwoofer.
Turnclockwisetoincreasethelevel.Ifthesoundbecomesdistorted
reducethelevel.
LOW PASS FILTER (LPF)
This allows the adjustment of the highest frequency the Active
Wedgewillproduce.Thisshouldbeadjustedtoblendwithyourmain
speakers.Typically,thiswillbesettoaround100Hz(approximately
thecentralpositionofthecontrolknob).
REMOTE LEVEL CONTROLLER
Whenconnected,thisallowsfurthercontroloverthelevelfroma
remotelocation,usingthesuppliedlead.
INSTALLATION
MakesuretheActiveWedgeisrmlyxedinyourvehicle.Check
beforedrillingorcuttingholes.DONOTworkneargastanks,fuel
lines,hydrauliclinesorelectricalwiring.
DO NOT mountthe Active Wedge in sucha wayas to pinchor
damagethewires.
Make sure everything is rmly connected, before attaching the
+12Vwire.Ensurethe+12Vwireisfusedascloseaspossibletothe
battery.Alwaysuseafusewiththerecommendedrating.
DISCLAIMER
AlwaysensuretheActiveWedgeissecurelyattached,toavoidmovement.FUSIONacceptsnoresponsibilityfordamageorinjuryinrelation
toinappropriatesecuringofthisproduct.
WIRING
• Connectthegroundwiretothevehiclerst(cleandirtandpaint
tobaremetal).
• Connecttheremoteon(bluewire).
• ConnecttheRCAcablesifapplicable,OR
• Connectthespeakerlevelwirebysplicingintotheheadunits
speakerwires.SeeNote1onreverse.
• Connecttheremotelevelcontrollerwiththesuppliedlead.
• Connectthe12volt(redwire)tothepositivebatteryterminal.
• Checkallconnections.