DDC4500SWH – GE 5.4 Cu. Ft. Large Capacity Modular Commercial Gas Dryer
Specification Revised 8/04
Dryer Dimensions (in inches)
Shipped with exhaust to the rear.
offers 2-way venting: left, right, or rear. Maximum
recommended exhaust duct length is 15 feet of 4" rigid ducting
with two 90° elbows and 4" a dampered wall cap.
(See Installation Instructions.)
– 115 Volts, 60 Hertz single phase. An individual branch
circuit, properly grounded for a 3-prong outlet, fused for 15- or
20-amp is required for each dryer. Gas rate input, 22000 BTU/
Hr. Maintains the thermostatically controlled heat flow to dry
clothes gently. Longer cool down period on Permanent Press
cycle helps prevent heat-set wrinkles. Separate thermostat
controls lower temperatures for Knit cycle drying. Factory
equipped for natural gas. Tested for LP gas. A conversion kit is
required for LP gas. Check installation instructions for correct
kit number. Have a qualified technician install the conversion
kit. Equipped with energy saving Glo-Bar ignition.
77
27
27
Gas Dryer
only
Cmmrcl. Front.eps
Access
Pane
l
Access
Pa
ne
l
11-3/4
41-5/8
3-1/2
3/4
1-7/8
2-3/8
DDC4400S Back View
Dimensions and specifications shown here are correct at the time this sheet was printed. Before
proceeding with construction or rough-in, check installation instructions that came with your unit.
Specifications, dimensions and design are subject to change without notice.
Wall anchor chain provided for gas models only.
For answers to your Monogram,
For answers to your Monogram,
®
For answers to your Monogram,
appliance questions, visit our website at
GEAppliances.com or call GE Answer Center
