9
HD5212
Menu Operation
Press and hold the rotary encoder (4) to access the system menu.
Repeatedly press the rotary encoder button to access menu options in the
following order:
• BEEP ON/OFF: The beep tone feature allows the selection of an
audible beep tone to be heard each time a button is pressed on the face
of the radio. “BEEP ON” is the default display. Rotate the rotary encoder
to select the “BEEP OFF” option.
• P--VOL: Turn the rotary encoder to select the default volume the radio
will assume when first turned on.
• PCLK ON/OFF: When “ON”, the clock and backlight will remain on
when the unit is turned off.
• PRI CLK/SRC: Select “CLK” to have the clock appear on the display
during playback. Select “SRC” to have the current source appear during
playback. Press the DISP button (7) to temporarily view the alternate
display (clock or source) temporarily.
• HOURS 12/24: This option allows selection of a 12 hour or 24 hour
clock format. “HOURS 12” is the default setting. Turn the rotary encoder
to change to the 24 hour clock format.
• S--MODE NORMAL/HD SEEK (adjustable only in RADIO mode):
Select “NORMAL” to allow the radio to search for both digital and
analog stations. Select “HD SEEK” to only search and broadcast digital
stations.
Equalizer
Press the EQ button (20) to choose one of the following pre-defined bass
and treble curves: FLAT > CLASSICS > POP M > ROCK M > DSP OFF.
Loudness
Press and hold the BAND button (3) toggle loudness on/off. When listening
to music at low volumes, this feature will boost the bass and treble ranges
to compensate for the characteristics of human hearing.
Auxiliary Input
To access an auxiliary device:
1. Connect the portable audio player to the AUX IN jack on the front panel
(12).
2. Press the SRC button (2) to select AUX mode.
3. Press SRC again to cancel AUX mode and go to the next mode.
Setting the Clock
If not already showing, press the DISP button (7) to display the clock. With
the clock displayed, press and hold the DISP button and the time will flash
on the display. Press the TUNE/CH >> button (10) to adjust the hours or the
TUNE/CH << button (11) to adjust the minutes. When in “HOURS 12”
mode, “AM” or “PM” will appear on the display to indicate AM or PM. When
no adjustment is made for five seconds, the time will become set and
normal operation will resume.
Front Panel Release
The (open) button (9) releases the mechanism that holds the front panel
to the chassis.
Detaching the Front Panel
To detach the front panel, first
press the (open) button and
allow the front panel to swing
down. Grasp the right side of
the front panel and push it to
the left and then pull to release
the right side. Remove the
front panel and store it in the
supplied carrying case.
Re-attaching the Front
Panel
To re-attach the front panel,
make sure the electrical
terminals on the back of the
panel are free of dust and dirt,
as debris could cause
intermittent operation or other
malfunctions. With the panel in
the open position, slide the left
side of the panel in place so
that it is correctly engaged,
then lightly press the right side
of the panel until it locks into
place. Lift to close.
PRESS
RPT SHFSCN
1
2
3
4
5
6
SEL
CAT/DIR
AUX IN
MONO DISP
EQ
BAND
SRC
TUNE/CH
MUTE
A~Z
0~9
PS
ENTER
IPOD
FILE/FOLDER
HD5212
SAT
READY