Filter
Top Products
— 12 —
English
Tuner features
Switch the frequency step used in seeks. The factory defaults
are 50 kHz for FM and 9 kHz for AM.
Turn the power off.
Hold down buttons #1 and #5, then turn the power back on.
The frequency step settings will be changed to 200 kHz for FM
and 10 kHz for AM.
When you change the frequency step settings, all memory
contents will be erased.
Returning Frequency Step Settings to Original Values:
Repeat steps 1 and 2 above.
NOTE
2
1
Frequency Step Setting
You can change the display used when listening to the radio.
Changing the Display:
Each time you press the DISP button, the display changes as
follows:
Character
Station frequency
SNPS name (only when being preset)
Clock
Spectrum analyzer
Switching Display for Tuner
You can assign names to radio stations with the Station Preset
Memory. Up to 30 stations can be assigned names.
Adjust the frequency to the station whose name you want to
enter.
This function cannot be available during the clock display.
Press the NAME.S button for at least two seconds.
"Name Set" is displayed once the station name preset mode is
entered.
The cursor will blink in the position where letters are entered.
Press either the 4 or ¢ button to move the cursor to the
desired position.
The 4 button moves the cursor to the left, and the ¢
button to the right.
Each time the 38 button is pressed, the characters to be
entered change as listed below.
Press the FM or AM button to display the desired character.
Characters that can be displayed are as follows.
Continue steps 3 and 4 until all the characters are chosen for
the name.
You can enter up to eight characters for each name.
Assigning Names
Press the NAME.S button.
The name of the station is stored in memory, and the Station
Name Preset mode ends.
Also, if you make no input for 10 seconds, the name will be
stored up to the point that you have entered, and the mode
6
NOTE
5
Alphabet (upper case)/Numerals/Symbols:
A ~ Z 0~9 / + –
Alphabet (lower case)/Numerals/Symbols:
a ~ z 0~9 / + –
4
3
2
NOTE
1
Station Name Preset (SNPS)
03.DPX-4020_M_US_PH4 02.6.3 3:54 PM Page 12