Filter
Top Products
— 31 —
Connecting Wires to Terminals
M4×8mmMAX
–
+
–
+
–
+
–
+
–
+
ANT
CONT
P.CONT
EXT
CONT
ILLUMI
ACC
BATT
FRONT•L
FRONT•R
REAR•L
REAR•R
When only two speakers are being connected to the
system, connect the connectors either to both the front
output terminals or to both the rear output terminals (do not
mix front and rear). For example, if you connect the +
connector of the left speaker to a front output terminal, do
not connect the - connector to a rear output terminal.
2CAUTION
KENWOOD disc changer control input
To connect the Disc changer,
consult your Disc changer manual.
NOTE
If you connect the ignition wire (red) and the battery wire
(yellow) to the car chassis (ground), you may cause a short
circuit, that in turn may start a fire. Always connect those
wires to the power source running through the fuse box.
2WARNING
FM/AM antenna input
Fuse
(10A)
Wiring harness
(Accessory5)
White/Black
Gray/Black
Green/Black
Purple/Black
White
Gray
Green
Purple
To front left
speaker
To front right
speaker
To rear right
speaker
To rear left
speaker
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
Ignition key
switch
Car fuse
box
(Main
fuse)
ACC
Car fuse box
Battery
When using the optional power amplifier,
connect to its power control terminal.
To car light control switch
Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power terminal for
the booster amplifier of the film-type antenna.
Power control wire
(Blue/White)
Motor antenna control wire
(Blue)
Automatic illumination/Dimmer
control wire (Orange/White)
Front left output (White)
Front right output (Red)
Rear left output (White)/
Non-fading left output (White)
Rear right output (Red)/
Non-fading right output (Red)
External amplifier control wire
(Pink / Black)
To "EXT.AMP.CONT." terminal of the amplifier
having the external amp control function.
03.DPX-4020_M_US_PH4 02.6.3 3:54 PM Page 31