Filter
Top Products
44
|
English
Menu system
In Standby mode
Built-in Amp Setting
Built-in amplifier is controlled.
Turning OFF this control enhances the preout
quality.
Display Setting
"AMP : ON" The built-in amplifier activates.
"AMP : OFF" The built-in amplifier deactivates.
Function of the KDC-X889/KDC-MP828/KDC-
MP7028/KDC-MP728/KDC-X789
In Standby mode
G-Counter Level set
Calibrating G-Counter. Setting the level according
to the kinds of vehicles.
Display Setting
"G-Counter: Level1" Counter is easy to go up.
"G-Counter: Level2"
…
"G-Counter: Level3" Counter is hard to go up.
• In the case of less acceleration, set it up to "G-Counter:
Level1". In the case of frequent acceleration, set it up
to "G-Counter: Level3".
Function of the KDC-X889/KDC-MP828/KDC-
MP7028/KDC-MP728/KDC-X789
In Standby mode
G-Analyzer Reset
Resets the value of G-Meter and G-Counter.
1 Select G-Analyzer Reset mode
Push the Control knob to [FM] or [AM].
Select the "G-Reset" display.
2 Enter G-Analyzer Reset mode
Press the Control knob for at least 1 second.
3 Select the Reset item
Push the Control knob to [FM] or [AM].
"G-Meter Reset": Reset the value of G-Meter.
"G-Counter Reset": Reset the value of G-Counter.
4 Reset the value
Press the Control knob for at least 2 seconds.
"Reset OK" is displayed.
5 Exit G-Analyzer Reset mode
Press the [MENU] button.
Function of the KDC-X889/KDC-MP828/KDC-
MP7028/KDC-MP728/KDC-X789
In Standby mode
G-Analyzer Calibration setup
G-Analyzer requires calibration for horizontal
acceleration and braking.
• Detection of horizontal and straight directions should
be done at horizontal location to go straight.
1 Park the vehicle at horizontal location
2 Select G-Analyzer Calibration set mode
Push the Control knob to [FM] or [AM].
Select the "G-Calibration" display.
3 Enter G-Analyzer Calibration set mode
Press the Control knob for at least 1 second.
"Stop" is displayed.
4 Start Calibration of horizontal direction
Press the Control knob.
Once "Move Forward" appears on the display, the
vehicle must be advanced.
5 Start Calibration of straight direction
When the vehicle is driven on the straight
direction, calibration of straight direction
automatically starts.
• In order to operate the detection of straight direction.
When the Calibration is finished, "Calibration OK"
is displayed.
• If you fail to complete the calibraton, "No Calibration"
is displayed. In such a case, repeats step 1 thru 6.
6 Exit G-Analyzer Calibration set mode
Press the [MENU] button.
Function of the KDC-X889/KDC-MP828/KDC-
MP7028/KDC-MP728/KDC-X789
G-Analyzer Stop Watch
The control of stop watch can be started by G-
Analyzer function.