Kenwood KIV-700 Car Satellite TV System User Manual


 
14
|
Quick Start Guide
Installation/Removing the Unit
Installation
Bend the tabs of the mounting sleeve
with a screwdriver or similar utensil
and attach it in place.
• Make sure that the unit is installed
securely in place. If the unit is unstable, it
may malfunction (for example, the sound
may skip).
Removing the hard rubber frame
1. Engage the catch pins on the removal
tool and remove the two locks on the
upper level.
Lift up and pull the frame forward as
shown in the figure.
Catch
Lock
Removal tool (Accessory
2)
2. When the upper level is removed,
remove the lower two locations.
• The frame can be removed from the
bottom side in the same manner.
Removing the Unit
1. Refer to the section <Removing the hard
rubber frame> and then remove the
hard rubber frame.
2. Insert the two removal tools deeply into
the slots on each side, as shown.
3. Lower the removal tool toward the
bottom, and pull out the unit halfway
while pressing towards the inside.
Accessory 2
¤
• Be careful to avoid injury from the catch
pins on the removal tool.
4. Pull the unit all the way out with your
hands, being careful not to drop it.
¤ CAUTION
Install this unit in the console of your
vehicle.
Do not touch the metal part of this unit
during and shortly after the use of the
unit. Metal part such as the heat sink and
enclosure become hot.