Kenwood KRC-677R Car Stereo System User Manual


 
With automatic time adjustment, you can set the clock time
automatically according to time data sent from RDS stations
(after receiving RDS signals for several minutes). You can also
set the time manually if the automatic time adjustment function
is turned off. The factory default is automatic time adjustment.
Adjusting Time Automatically:
Tune into an RDS station for 3 or 4 minutes.
The time adjusts automatically to the correct local time.
The time is not adjusted when the RDS station you are tuned to is
not transmitting a time signal. Choose another RDS station in
such a case.
NOTE
Adjusting Time
Function of the KRC-677R
This adjustment permits easy viewing of the display.
To adjust the contrast:
Hold down the MENU button for one second or more.
"MENU" is displayed and the menu mode is turned on.
Press the ¢ button repeatedly until the Contrast Adjustment
function appears in the display.
Press the 4 button to search in the other direction.
The function setting is indicated by "CONT ##" in the display,
indicating that the Contrast Adjustment mode is on.
Switching settings
Press either the AM or FM button.
Press the FM button to change the setting values higher, and
press the AM button to change them lower. Settings may be
made from 0 to 10.
Press the MENU button to end the menu mode.
The "##" display in the contrast adjustment mode will differ
depending on the setting. The initial setting value is "5".
NOTE
4
3
2
1
Contrast Adjustment
When the KENWOOD Navigation System is connected, an
interruption of the audio guide results in the temporary
lowering of the audio level.
The Navigation mute function cannot be used unless a TEL mute
cable is connected to the KENWOOD Navigation System.
NOTE
Navigation Mute Function
This function produces a beep sound that accompanies button
operation. It can be switched on or off.
Turning the Beep On/Off:
Hold down the MENU button for one second or more.
"MENU" is displayed and the menu mode is turned on.
Press the ¢ button repeatedly until the Touch Sensor Tone
function appears in the display.
Press the 4 button to search in the other direction.
The function setting is indicated by "Beep ON" or "Beep OFF" in
the display, indicating that the current beep setting is on or off,
respectively.
Switching settings
Press either the AM or FM button.
The display and setting will change.
Press the MENU button to end the menu mode.
The beep sound is not output from the preout jacks.
NOTE
4
3
2
1
Touch Sensor Tone
Other features
— 30 —
English