Filter
Top Products
— 39 —
The following messages are displayed when certain problems are occurring in your system. Take the recommended
actions.
Nothing has been recorded on the MD.
] The next MD is automatically played back
BLANK
No disc magazine has been loaded in the changer. The disc magazine is not completely loaded.
] Load the disc magazine properly.
No CD in the unit.
] Insert the CD.
EJECT
No tracks are recorded on the MD, although it has a title.
] The next MD is automatically played back.
NO TRACK
The unit is malfunctioning for some reason.
] Press the reset button on the unit. If the "E- 77", code does not disappear, consult your nearest service centre.
E-77
Something is wrong with the disc magazine. Or the unit is malfunctioning for some reason.
] Check the disc magazine. And then, press the reset button on the unit.
If the "E- 99" code does not disappear, consult your nearest service center.
E-99
The protective circuit in the unit activates when the temperature inside the automatic disc changer exceeds 60°C (140°F), stopping
all operation.
] Cool down the unit by opening the windows or turning on the air conditioner. As the temperature falls below 60°C (140°F), the
disc starts playing again.
HOLD
If this indicator continues blinking, it is possible that the tape has become jammed or tangled.
] Contact the Kenwood dealer if the tape cassette cannot be ejected.
¢
No disc has been loaded in the disc magazine.
] Load a disc into the disc magazine.
The CD is very dirty. The CD is upside-down. The CD is scratched a lot.
] Clean the CD and load it correctly.
E-04
No disc has been loaded in the disc magazine.
] Load a disc into the disc magazine.
NO DISC
The faceplate of the slave unit being connected to this unit has been removed.
] Replace it.
NO PANEL