Filter
Top Products
6.
OPTIONAL ACCESSORIES
The following accessories are available for more sophisti-
cated operation of your receiver.
•
HS-7 MICRO HEADPHONES (16 OHMS)
•
HS-6 COMMUNICATIONS HEADPHONES
(12.5 OHMS)
Deluxe, very light-weight headphones designed for com-
munications equipment.
■
HS-5 COMMUNICATIONS HEADPHONES
(8 OHMS)
Headphones designed for communications equipment.
These light-weight open air-type headphones remain com-
fortable during extended operation. Easily attached ear-
•
IF-232C INTERFACE
The IF-232C Interface is the adapter for connection bet-
ween the RS-232C terminal of a personal computer and
the interface terminal of the R-5000.
•
MB-430 MOBILE MOUNT
The Mobile Mount MB-430 allows easy installation and re-
moval of the R-5000. The MB-430 can either be suspend-
ed from the dashboard or attached to the transmission
tunnel or a center console. The transceiver tilt angle can
be adjusted 5 steps.
Caution:
Optional accessories should be installed by qualified ser-
vice personnel to prevent personal injury or damage to the
equipment.
The following optional Crystal Filters can be used to re-
duce adjacent channel interference.
■
YK-88C CW FILTER
Center frequency
: 8,830.7 kHz
Passband width
: 500 Hz (– 6 dB)
Attenuation bandwidth
: 1.5 kHz (– 60 dB)
Guaranteed attenuation
: More than 80 dB
■
YK-88CN CW NARROW FILTER
Center frequency
: 8,830.7 kHz
Passband width
: 270 Hz (– 6 dB)
Attenuation bandwidth
: 1.1 kHz (– 60 dB)
Guaranteed attenuation
: More than 80 dB
•
YK-88SN SSB NARROW FILTER
Center frequency
: 8,830.0 kHz
Passband width
: 1.8 kHz (– 6 dB)
Attenuation bandwidth
: 3.3 kHz (– 60 dB)
Guaranteed attenuation
: More than 80 dB
•
YK-88A-1 AM FILTER
Center frequency
: 8,830.0 kHz
Passband width
: 6 kHz (– 6 dB)
Attenuation bandwidth
: 11 kHz (– 60 dB)
Guaranteed attenuation
: More than 80 dB
•
VC-20 VHF CONVERTER UNIT
The VHF Converter Unit for the R-5000 covers the fre-
quency range between 108 MHz and 174 MHz (with West
Germany version: 144 MHz to 146 MHz).
•
IC-10 INTERFACE IC KIT
The Interface IC Kit is designed to be installed internally in
the R-5000 to allow computer assisted control of various
receiver operating parameters.
Control is performed thru a computer's RS-232C terminal
thru the IF-232C Interface (level translator).
•
VS-1 VOICE SYNTHESIZER UNIT
When the VS-1 Voice Synthesizer Unit is installed, the dis-
played frequency is announeced by synthesized voice.
•
DCK-2 DC OPERATION KIT
The DCK-2 is the DC power cable kit for DC operation of
the R-5000.
2-pin connector manufacturer: KENWOOD CORPORATION
Part number
: E30-2055-05
29