Filter
Top Products
OPERATING FEATURES
4-5.
Clone Mode (Figure
51
Programmed data is transferred from one
transceiver to another by using a microphone cable.
1.
Connect the master set to the slave set with.
2.
Turn the slave set on
3.
Hold down the AUX key, turn the master set on, and
keep the AUX key down for two more seconds.
"CLONE" appears on the display to indicate that
clone mode has been entered.
4.
Press the SCAN key on the master set.
The
a
mark appears and data is sent from the
master set to the slave set. "PROGRAM" appears
on the slave set to show that it is receiving data.
5.
When cloning is complete, the
a
mark on the
master set disappears and
"CLOIVE" changes to
"END". The slave set is automatically reset and
enters user mode.
If cloning fails, the master set shows "ERROR".
Repeat steps
4
and
5.
If you wish to clone several sets, switch each of
them
on and reDeat
4
and
5.
5.
Description of Each Modes
5-1.
Dealer mode
To enter this mode, hold down the GROUP UP key,
turn the transceiver on, and keep the GROUP UP key
down for two more seconds The mode can be
inhibited by programming.
SYSTEM key
Used to select one of programmed frequencies
1
to
16.
If no frequency data has been preset, the
frequency listed in Table
1
is written as the default
value.