Filter
Top Products
75
CONNECTING PERIPHERAL EQUIPMENT 13
DX PACKETCLUSTER TUNE
If you have a TH-D72(A/E)/ TM-D710/G(A/E)/ RC-D710/ TM-D700(A/E), you can connect the TH-D72(A/E)/ TM-
D710/G(A/E)/ RC-D710/ RC-D710/ TM-D700(A/E) to the TS-590SG transceiver to use the DX PacketCluster Tune
function. Connect the 2 transceivers with a cross-wired RS-232C cable as shown below. (For connecting to the
TH-D72(A/E), refer to the TH-D72(A/E) instruction manual.)
RC-D710 + PG-5J
TM-D700(A/E)
TS-590SG
TM-D710/G(A/E)/
RC-D710 + TM-V71(A/E)
(m)
(f)
(f)
(f)
PG-5G
RS-232C cross cable
CROSSBAND REPEATER
If you have a KENWOOD FM transceiver (K type) with a 6 pin mini DIN connector, you can connect the FM
transceiver to the TS-590SG transceiver to use the Crossband repeater function. Connect the 2 transceivers with a
DIN (13-pin)/ mini DIN cable (6-pin) as shown below.
TM-D700A
TS-590SG
TM-D710GA/
TM-D710A/
TM-V71A
PR1
SQC
PKSPSQ
PKD
PKS
ANI
ANO
DIN (13-pin)/ Mini DIN (6-pin)
DIN (13-pin) plug Mini DIN (6-pin) plug
After connecting the 2 transceivers with the cable, access Menu Nos. 80 (PKS polarity) and 81 (Busy lockout) on
the TS-590SG transceiver and select “on”. You will further need to adjust the audio input/ output level of the TS-
590SG transceiver using Menu Nos. 73 and 74.