LG Electronics 32LH255H Car Satellite TV System User Manual


 
21
206-4118
Before you begin cloning:
• The Master TV should be connected to a good, stable
signal from an over-the-air antenna or cable service
analog channel and should also be connected to power
(see above).
• Teaching and Learning is only possible between identical
model devices. (However, the LT2002 Clone Programmer
can store up to three different “Master” Setups.)
WARNING: Copying a blank or incorrect memory into a
TV, STB, or other device will cause the TV, STB, or other
device to operate erratically or become inoperable.
• Use an Installer Remote to operate Learning and
Teaching menus.
• Make sure the batteries in the Clone Programmer are
fresh.
• If batteries are removed, the Clone Clock Time will be lost.
• Decide if you want to set the time from the Clone
Programmer or copy the time to the Clone Programmer
from a compatible TV which has the clock set to the cur-
rent time.
• Setting the time and transferring it to the Clone
Programmer or other device is a separate procedure.
• Follow the connection diagram above to connect the
Clone Programmer to a Master TV display panel. After
Learning is complete, connect to another identical TV
display panel to “teach” it the Master Setup.
• Refer to “LT2002 Cloning Procedure Troubleshooting”
information to resolve problems.
Ferrite Core
(TDK, ZCAT
2035-0930)
THE CLONE HAS CONTROL OF THE TV
THE CLONE IS VERSION XX
THE TV IS VERSION XX
THE SW IS REVISION XX
CLONE CLOCK= XX:XX
TV CLOCK= XX:XX
-PRESS ANY KEY TO CONTINUE.
-DISCONNECT CLONE WHEN DONE.
Antenna
or CATV
Master TV
Clone Programmer
QuickSet II Programmer
LT2002
®
ZENITH ELECTRONICS CORPORATION, LINCOLNSHIRE, ILLINOIS, USA
tIFBSUCFBUQPXFSPO
communications ok
tTMPX QPXFSPO
no communications
tHSFFO CBUUFSZPL
tSFE CBUUFSZMPX
#MJOLQBUUFSO
$PMPS
Reset
Status
*OEJDBUPS
$POOFDUDBCMFUP
57.1*+BDLBOE
GPMMPXPOTDSFFO
instructions
MPI
Connections for the LT2002 Clone Programmer to Learn the Master TV Setup
Note: These procedures assume that the TV is connected to a signal source, the TV source select-
ed is Antenna (RF) In, the signal is from an analog channel (not a digital channel), all equipment is
connected to power and turned ON, and the LT2002 Clone Programmer main menu (THE CLONE
HAS CONTROL OF THE TV) is displayed on the TV screen (see above and next page).
LT2002 Cloning Connections / Learning Setup
Warning: Do not use the
LT2002 while any PPV card is
installed in the TV, or the Clone
Programmer device and the
PPV card will be damaged.
If an analog channel is not available, tune the TV to an Aux source, such as AV-1, for cloning purposes.
Continue the Cloning Setup on the next page.