Panasonic BT-LH910G Car Video System User Manual


 
54
3D Assist Mode
(continued)
MIRROR (Left/Right and Top/Bottom inversion)
This function inverts just the left and right or top and bottom or both the left and right and top and bottom of
the input signals of SDI2 (R) to enable the basic adjustments of a rig-type 3D camera system (half mirror
type) to be made.
TB MIRR
MIRROR
FUNC.
Screen:
The L/R 2 screens are shown side-by-side.
<Notes>
Left and right inversion and top and bottom
inversion are also reflected in other assist
functions.
The inversion setting information is even saved
when the power is turned off.
Sub menu Operation Settings Description
MIRROR Knob1 (turn)
OFF
LR
TB
LRTB
Inverts the left and right and the top and bottom of the input
signals on the SDI2 (R) side.
<OFF> Do not invert <LR> Invert Left and Right
<TB> Invert Top and Bottom
<LRTB> Invert Both Left and Right/Top and Bottom
SHIFT (Horizontal and Vertical Shift)
This function shifts the images of SDI2 (R) horizontally or vertically to enable you to overlay the images.
You can check the lens axis of a rig-type camera system while checking the rotation offset of the image.
H
V
FUNC.
0 0 SHFT
Screen:
L/R are overlaid in one screen.
<Note>
The setting information for shifting images with
the SHIFT function is not memorized. The initial
display state is restored when you switch to the
COMPARISON function or another assist function.
Sub menu Operation Settings Description
H Knob1 (turn)
-128 - 0 - 127 Shifts the images on the SDI2 (R) side horizontally.
V Knob2 (turn)
-32 - 0 - 31 Shifts the images on the SDI2 (R) side vertically.
COMPARISON (Composition Check)
This function is for checking when the subject is captured with only the camera of one side.
FUNC.
CMPR
Screen:
The L/R 2 screens are shown side-by-side, and a
70% size half-tone marker is shown inside each of
the images.
<Assist Point>
If there is an image shown on either only the left or
right, discomfort will be felt and stereoscopic vision
will become difficult when the mode is set to 3D.
Perform a comparison check of the parts of the
images outside of the markers.
The underlined values are factory preset setting values.
The underlined values are factory preset setting values.