Filter
Top Products
E
N
G
L
I
S
H
2
CQ-DF202W
11
E
N
G
L
I
S
H
1
CQ-DF202W
10
Power and Sound Controls
Pattern 1 Pattern 3
Pattern 4Pattern off
Pattern 2
(Default)
Power
Turn the key in the ignition until the accessory in-
dicator lights.
Power on: Press [SOURCE] (PWR).
Power off: Press [SOURCE] (PWR) again and
hold.
Mute
Press [MUTE] to mute the sound completely.
Press [MUTE] again to cancel.
Note:
≥When the power is switched on for the first
time, a demonstration message appears on the
display.
To cancel this display, press [DISP] (display).
Volume
[" VOL]: Up
[# VOL]: Down
Press and hold for rapid adjustment.
Volume level (0 to 40)
Anti-volume-blast circuit:
When the power is switched off and on again,
the volume slowly rises to the previous level.
The anti-volume-blast circuit will not work when
the volume level is set lower than position 20 on
the display.
MUTE
VOL
S
C
A
N
A
U
T
O
·P
SEL
BAND
TUNE
MUTE DISP
12
34
5
6
712
C
LO
C
K
SOURCE
REP
CQ-DF202W
CD RECEIVER WITH CHANGER CONTROL
45W
X
4
RANDOM
OPEN
PWR
811
910
TRACK
LOUD
M
O
N
O
/L
O
C
LEVL
REMOTE
VOL
S
C
A
N
A
U
T
O
·P
SEL
BAND
TUNE
MUTE DISP
12
34
5
6
712
CLO
C
K
SOURCE
REP
CQ-DF202W
CD RECEIVER WITH CHANGER CONTROL
45W
X
4
RANDOM
OPEN
PWR
811
910
TRACK
LOUD
M
O
N
O
/L
O
C
LEVL
REMOTE
Audio Mode
(Bass/Treble/Balance/Fader)
Regular mode
Volume Bass Treble
BalanceFader
Note:
≥If no operation takes place for more than 5 seconds
in audio mode (2 seconds in volume mode), the dis-
play returns to the regular mode.
Bass:
Adjustable range: j12 dB to i12 dB
(by 3 dB step)
Treble:
Adjustable range: j12 dB to i12 dB
(by 3 dB step)
Balance:
R (right speaker) or L (left speaker)
Fader:
F (front speaker) or R (rear speaker)
Adjustable range: Balance center
1 to 15 (by 1 dB step)
Adjustable range: Fader center
1 to 15 (by 1 dB step)
Loudness
Press [LOUD] to enhance bass and treble
tones at low or medium volume.
Press [LOUD] again to cancel.
LOUD
Level Meter
When the power is on, the level of sound sources,
such as radio and CD, is displayed.
Press [LEVL] (level) to change the level meter dis-
play.
AC
C
ON
Press [SEL] to select the audio mode.
1
Press [" VOL] or [# VOL] to change each
level.
2
Clock Basics
The 12-hour system is used for the clock.
Hours
2 Press and hold [DISP] (CLOCK) for more than
2 seconds.
3 Press [% TUNE] or [$ TUNE].
Minutes
4 Press [DISP] (CLOCK).
5 Press [% TUNE] or [$ TUNE].
6 Press [DISP] (CLOCK).
Note:
≥Press and hold [% TUNE] or [$ TUNE] for more
than 2 seconds to change numbers rapidly.
(Hours blink.)
(Hours set.)
(Minutes blink.)
(Minutes set.)
(End.)
Initial Time
1 Press [DISP] (CLOCK).
(Clock display.)
Time Reset
Press and hold [DISP] (CLOCK) for more than
2 seconds to activate the time setting mode to
reset the time.
Then, repeat steps 3 to 6.
[DISP] (CLOCK)[% TUNE], [$ TUNE] (Hours, minutes)