Panasonic CQ-VX2200W Car Stereo System User Manual


 
41
CQ-VX2200W
1
E
N
G
L
I
S
H
32
Trouble Cause / Step
Tape running mechanism is dirty or out of order.
aClean tape running mechanism, or repair it. (Ask a service representative
for advice.)
Heads are magnetized.
aDemagnetize heads. (Ask a service representative for advice.)
Normal type tape plays with Metal mode.
aChange Metal mode to Normal mode.
Non-Dolby B NR tape plays with Dolby B NR on.
aSet Dolby B NR to OFF.
Metal type tape plays with normal mode.
aChange Normal mode to Metal mode.
Dolby B NR tape plays with Dolby B NR off.
aSet Dolby B NR to ON.
Cassette Tape (continued)
Reproduction of high
tones is poor.
Wow and flutter is very
high.
Trouble Cause / Step
No sound from left,
right, front, or rear
speaker
Left and right sounds
are reversed in stereo
listening.
Only bass or monaural
sound from rear speaker
SBC-SW is set to ON.
aSet SBC-SW to OFF.
The right speaker wire is connected to the left speaker and the left speaker wire
to the right speaker.
aConnect the speaker wires to the correct one.
Cables are not correctly connected.
aConnect the cables correctly.
Left and right balance, or front and rear balance is off on one side.
aAdjust BAL//FAD as appropriate.
Sound Setting
Trouble Cause / Step
Buttons are invalid for
operation.
Remote control is in the wrong direction.
aDirect the remote control at sensor (REMOTE) on the panel.
Battery has run down.
aReplace the battery.
Wrong battery.
aCheck the battery.
Battery poles (+) (–) are reversed.
aInsert the battery correctly.
Remote Control
High tones are improp-
erly emphasized.