Filter
Top Products
CR-SRF100/CR-SRT100
45
• The antenna should be installed on the vehicle’s roof with the 2 wires separating and going around
the rear window before entering the vehicle and going to the receiver. The antenna is fastened to
the roof top with self-adhesive tape located on the bottom of the antenna housing.
To obtain optimum adhesion, the bonding surface must be clean, dry and well unified. Typical surface
cleaning solvents are isopropyl alcohol/water mixture (rubbing alcohol) or heptane. However, if placing it on
a painted surface, test first to ensure no damage to the surface will occur.
- Use a clean cloth to clean surface.
- Use proper safety precautions for handling solvents.
It may be necessary to seal or prime some substrates prior to bonding:
a. Most porous or fibered materials (e.g. wood) will require sealing to provide a
unified surface.
b. Some materials (e.g. copper, brass, plasticised vinyl) will require priming or coating
to prevent interaction between adhesive and substrates.
Ideal tape application temperature is 20°C to 38°C (68°F ‡ 100°F). Do not apply to surfaces below 10
degrees Celsius.
In some cases, bond strength can be increased and ultimate bond strength can be achieved more quickly
by exposure of the bond to elevated temperatures (e.g. 85°C [185°F] for one hour).
The antenna is sold separately. Read and follow instructions included with
the antenna. Information below is provided as reference only.
Warning: Panasonic is not responsible for scratches or other surface damage that might result from removing a
Satellte Radio Antenna after it has been installed.
17233_SGould 08/15/02 14:46 Page 45