Pioneer AVH-P5200BT Car Stereo System User Manual


 
Important
Never turn the unit off and never disconnect the
phone while the software is being updated.
1 Display the system menu.
Refer to Introduction of menu operations on
page 54.
2 Touch Bluetooth Software Update.
3 Touch Start to display the data transfer
mode.
# Follow the on-screen instructions to finish up-
dating the software.
Displaying the Bluetooth
system version
(AVH-P5200BTonly)
If this unit fails to operate properly, you may
need to consult your dealer for repair. In such
cases, you may be asked to specify the system
version. Perform the following procedure to
check the version on this unit.
1 Turn the unit off.
Refer to Basic Operations on page 11.
2 Display the system menu.
Refer to Introduction of menu operations on
page 54.
3 Touch Bluetooth Version Information to
display to the version of the Bluetooth
module of this unit.
Adjusting the LCD panel slide
position
You can adjust the LCD panel slide position so
that the panel is set back or forward.
1 Display the system menu.
Refer to Introduction of menu operations on
page 54.
2 Touch Flap Set Back.
3 Touching the Flap Set Back keys allows
you to move the LCD panel back and forth.
The LCD panel slides to the back.
The LCD panel slides to the front.
Setting the automatic open
function
To prevent the display from hitting the shift
lever of an automatic vehicle when it is in the
P (park) position, or when you do not wish the
display to open/close automatically, you can
set the automatic open function to manual
mode.
1 Display the system menu.
Refer to Introduction of menu operations on
page 54.
2 Touch AUTO FLAP to select whether to
open/close the display automatically or
manually.
Each time you touch AUTO FLAP the setting
switches between:
! ON The LCD panel will open or close auto-
matically when the ignition switch is turned
on or off.
! OFF You have to press OPEN/CLOSE to
open/close the LCD panel.
Switching the warning tone
If the front panel is not detached from the
head unit within four seconds of turning off
the ignition, a warning tone sounds. You can
turn off the warning tone.
1 Display the system menu.
Refer to Introduction of menu operations on
page 54.
En
64
Section
14
Menu operations