Pioneer AVH-P6400CD Car Stereo System User Manual


 
En
15
English
Español
Deutsch
Français
Italiano
Nederlands
02
Section
Turning the unit on
1 Turn your vehicles engine ON.
The display will be automatically deployed by
the automatic close/open mode.
If the display is not automatically deployed,
press OPEN/CLOSE.
2 Press SOURCE to select the tuner.
Press SOURCE until you see Tuner displayed.
Closing the Display
Turn the vehicles engine OFF.
The display will be automatically closed by the
automatic close/open mode. If the display does
not close automatically, turn the ignition switch
ON again (or turning it to ACC) and press
OPEN/CLOSE.
Notes
The automatic close/open mode will operate
the display as follows.
When the ignition switch is turned OFF
while the display is deployed, the display
will be closed after approximately 6 sec-
onds.
When the ignition switch is turned ON
again (or turned to ACC), the display will be
deployed automatically.
Installing the operation panel will automat-
ically deploy the display. (Refer to page 11.)
The automatic close/open mode can be
switched ON/OFF. (Refer to page 63.)
When the ignition switch is turned OFF after
the display has been closed, turning the igni-
tion switch ON again (or turning it to ACC)
will not deploy the display. In this case, press
OPEN/CLOSE to deploy the display.
Screen Angle Adjustment
The angle of this products screen continues
changing as long as you keep pressing the
ANGLE button.
Adjust the screen to an easily viewable angle.
Important
If you can hear the display knocking against
your vehicles console or dashboard, press
ANGLE on the () side to move the screen a
little forward.
Notes
When adjusting the angle, be sure to press
ANGLE. Forcible adjusting of the display by
hand may damage it.
The adjusted angle of the display will be mem-
orized and automatically returned to the next
time the display is deployed.
TEXT
Power ON/OFF