Filter
Top Products
Black plate (4,1)
Parking brake interlock
Certain functions (Videoviewing and certain
touch panel keys)offered by this unit couldbe
dangerous and/or unlawfulif used while driving.
To preventsuch functions from being usedwhile
the vehicle isin motion, there is aninterlock sys-
tem that senseswhen the parking brake isset. If
you attempt touse the functions described
above while driving,they will become disabled
until you stopthe vehicle in a safeplace, and (1)
apply the parkingbrake, (2) release the parking
brake, and then(3) apply the parking brake
again. Please keepthe brake pedal pushed
down before releasingthe parking brake.
When using a display connected
to rear monitor output
The rear monitoroutput on this unit (VOUT)is
used to connecta rear display that allowspas-
sengers in therear seats to watch videos.
WARNING
NEVER install therear display in a location
where the drivercan watch videos while driving.
When using the rear view camera
With an optionalrear view camera, this unit can
be used asan aid to keep aneye on trailers, or
when backing intoa tight parking spot.
WARNING
! SCREEN IMAGEMAYAPPEAR RE-
VERSED.
! USEINPUT ONLYFOR REVERSE OR
MIRROR IMAGE REARVIEW CAMERA.
OTHER USE MAY RESULTIN INJURY
OR DAMAGE.
CAUTION
! Therear view camera functionis to be used
as an aid tokeep an eye ontrailers, or while
backing up. Donot use for entertainment
purposes.
! Pleasenote thatthe edges of the rear view
camera images maydiffer slightly according
to whether full screen imagesare displayed
when backing up,and whether the images
are used forchecking the rear when the ve-
hicle is movingforward.
To avoid battery exhaustion
Keep the vehicleengine running when using
this unit toavoid draining the battery power.
! Whenno poweris supplied to this unit, such
as when thevehicle battery is beingre-
placed, the microcomputerof this unit re-
turns to itsinitial condition. We recommend
that you transcribethe audio adjustment
data.
WARNING
Do not usewith vehicles that do notfeature an
ACC position.
Information to User
FCC ID: AJDK062
MODEL NO.: AVH-X7500BT
IC: 775E-K062
This device complieswith Part15 of FCC
Rules and Industry Canadalicence-exempt
RSS standard(s). Operationis subject to the
following two conditions:(1) this device may
not cause interference, and (2)this device
must accept anyinterference, including inter-
ference that maycause undesired operation
of this device.
This transmitter mustnot be co-located or op-
erated in conjunctionwith any other antenna
or transmitter.
The Bluetooth antennacannot be removed (or
replaced) by user.
This equipment complieswith FCC/IC radia-
tion exposure limitsset forth for an uncon-
trolled environment andmeets the FCC radio
frequency (RF) ExposureGuidelines in Sup-
plement C toOET65 and RSS-102 of the IC
radio frequency (RF)Exposure rules. This
equipment has very low levelsof RF energy
that it deemedto comply without maximum
permissive exposure evaluation(MPE). But it
is desirable thatit should be installed andop-
erated keeping theradiator at least 20cmor
more away fromperson’s body (excluding ex-
tremities: hands, wrists,feet and ankles).
MODEL NO.: AVH-X6500DVD
This device complieswith Part15 of the FCC
Rules. Operation issubject to the following
two conditions:
(1) this devicemay not cause harmful interfer-
ence, and (2)this device must accept anyin-
terference received, including interference
that may cause undesiredoperation.
Alteration or modificationscarried out with-
out appropriate authorizationmay invalidate
the user’s right to operate theequipment.
Note
This equipment hasbeen tested and found
to comply withthe limits for a ClassB digital
device, pursuant toPart 15of the FCC Rules.
These limits aredesigned to provide reason-
able protection againstharmful interference
in a residentialinstallation. This equipment
generates, uses andcan radiate radio fre-
quency energy and,if not installed and used
in accordance withthe instructions, may
cause harmful interference to radiocommu-
nications. However,there is no guarantee
that interference will not occurin a particu-
lar installation. Ifthis equipment does cause
harmful interference to radio ortelevision re-
ception, whichcan be determined by turning
the equipment offand on, the useris encour-
aged to try to correctthe interference by one
or more of thefollowing measures:
- Reorient orrelocate the receiving antenna.
- Increase theseparation between the equip-
ment and receiver.
- Connect the equipmentinto an outlet on a
circuit different fromthat to which the re-
ceiver is connected.
- Consult the dealeror an experienced radio/
TV technician forhelp.
Precautions
4
Section
Before you start
En
01
02
<CRD4711-B>4