Filter
Top Products
Black plate (44,1)
iPod with 30-pin connector
When connecting with optional
CD-IU201V cable
This product
Interface cable
(CD-IU201V) (sold separately)
AUX input (AUX IN)
1.5 m (4 ft. 11 in.)
Dock connector
USB cable
(Supplied with this unit)
Connect to separately sold
USB device.
USB/iPod input
iPod with video
capabilities
(sold separately)
17 cm (6-3/4 in.)
When connecting with optional
CD-IU201S cable
This product
1.5 m (4 ft. 11 in.)
Dock connector
USB cable
(Supplied with this unit)
Connect to separately sold
USB device.
USB/iPod input
iPod with video
capabilities
(sold separately)
RGB input
Interface cable
(CD-IU201S) (sold separately)
Notes
! Checkall connectionsand systems before
final installation.
! Donot use unauthorizedparts as this may
cause malfunctions.
! Consultyour dealerif installation requires
drilling of holesor other modifications to the
vehicle.
! Donot install thisunit where:
— itmay interfere withoperation of thevehicle.
— itmay cause injury toa passengeras aresult
of asudden stop.
! Thesemiconductor laser willbe damaged if
it overheats. Installthis unit away from hot
places such asnear the heater outlet.
! Optimumperformance is obtained whenthe
unit is installedat an angle of lessthan 30°.
! Wheninstalling, to ensureproper heat dis-
persal when usingthis unit, make sure you
leave ample spacebehind the rear panel and
wrap any loosecables so they are notblock-
ing the vents.
5cmcm
Leave ample
space
5 cm
5 cm
! Thecords mustnot cover up the area shown
in the figurebelow.This is necessary to allow
the amplifiers toradiate freely.
1
1 Do not coverthis area.
! Makesure you leaveenough gap between
the dashboard andthe LCD panel of this unit
so the LCDpanel can be opened andclosed
without contacting withthe dashboard.
1
2
3
1 Dashboard
2 Leave gap
3 LCD panel
DIN front/rear-mount
This unit canbe properly installed using either
front-mount or rear-mountinstallation.
Use commercially availableparts when instal-
ling.
DIN Front-mount
1 Decide the positionof the side brackets.
When installing ina shallow space, change the
position of sidebrackets (small).
Connection
44
Section
Installation
En
23
24
<CRD4711-B>44