Filter
Top Products
Audio Adjustments
Note
• When you make adjustments for listening
position, the speakers are automatically set
for appropriate output levels. You can tailor
them if you want as discussed under the
heading of Adjusting the speaker output levels
using a test tone or Adjusting the speaker
output levels.
Using balance adjustment
You can select a fader/balance setting that pro-
vides an ideal listening environment in all occu-
pied seats.
1 Press AUDIO to select Fad.
Press AUDIOuntil Fad appears in the display.
• If the balance setting has been previously
adjusted, Bal will be displayed.
2 Press 5or ∞to adjust front/rear speaker
balance.
Each press of 5 or∞ moves the front/rear
speaker balance to the front or the rear.
• Fad F25 – Fad R25is displayed as the
front/rear speaker balance moves from front to
rear.
• Fad F/R 0 is the proper setting when only two
speakers are used.
3 Press 2or 3to adjust left/right speaker
balance.
When you press 2 or 3, Bal L/R 0 is displayed.
Each press of 2 or3 moves the left/right
speaker balance to the left or the right.
• Bal L25 – Bal R25 is displayed as the
left/right speaker balance moves from left to
right.
Adjusting source levels
SLA (source level adjustment) lets you adjust
the volume level of each source to prevent radi-
cal changes in volume when switching between
sources.
• Settings are based on the FM tuner volume
level, which remains unchanged.
1 Compare the FM tuner volume level with
the level of the source you want to adjust.
2 Press AUDIO to select SLA.
Press AUDIOuntil SLA appears in the display.
3 Press 5or ∞to adjust the source volume.
Each press of 5 or∞ increases or decreases
the source volume.
• SLA +4 – SLA –4 is displayed as the source
volume is increased or decreased.
Notes
• Since the FM tuner volume is the control, it is
not possible to apply source level adjustments
to the FM tuner.
• The AM tuner volume level can also be
adjusted with source level adjustments.
• Video CD and CD are set to the same volume
adjustment setting automatically.
• External unit 1 and external unit 2 are set to
the same volume adjustment setting automat-
ically.
En
8
02
Section