Filter
Top Products
ïð
Í
ÐÛÝ×Ú×ÝßÌ×ÑÒÍ
ÓÑÜÛÔó ÐÑÉÛÎÌëððóï¾¼Ìïëððóï¾¼
ݱ²¬·²«±«- б©»® ο¬·²¹ øÎÓÍ÷ ó Ó»¿-«®»¼ ¿¬ ïìòì Þ¿¬¬»®§ ʱ´¬-
4Load Bridged250 Watts x 1500 Watts x 1
2Load Bridged400 Watts x 11000 Watts x 1
1Load Bridged500 Watts x 11500 Watts x 1
Dimensions:Height2.14" (5.42cm)2.14" (5.42cm)
Width8.14" (20.68cm)8.14" (20.68cm)
Length11.41" (28.97cm)14.91" (37.86cm)
Battery Fuse Rating (Amp) External100A200A
(Not Supplied)
A! Weighted Signal to Noise Ratio
Referenced to 1 Watt into 4 ohms 80 dB
A! Weighted Signal to Noise Ratio
Referenced to rated output into 4 ohms 100 dB
Crossover Slope24dB/octave Butterworth
Crossover Frequencyvariable from 35Hz to 250Hz
Frequency Response20Hz to 250Hz ±0.5dB
Signal Voltage Adjustment RangeVariable from 150mV to 5V (RCA Input)
ProtectionShort circuit protection shut downs the amplifier in
case of very low impedance or shorted speaker wires.
Thermal switch shuts down the amplifier in case of overheating.
Equalization PEQ (Punch Equalization)Variable from 0dB to +18dB @ 45Hz
Input Impedance20K ohms
Infrasonic FilterSelectable 12dB/Octave,-3dB @ 28Hz
Operating Voltage9 to 16 Volts DC
Balanced InputsYes
CMRR (Common Mode Rejection Ratio)>55dB @ 1KHz
Damping Factor>200
THD+N (Total Harmonic Distortion + Noise) (T500-1bd)< 0.5% @ 1 ohm
THD+N (Total Harmonic Distortion + Noise) (T1500-1bd)< 0.8% @ 1 ohm
These specifications are Amplifier Power Standard CEA-2006 Compliant
Í°»½·º·½¿¬·±²- -«¾¶»½¬ ¬± ½¸¿²¹» ©·¬¸±«¬ ²±¬·½»