Open as PDF
Menu item details
The menu will differ depending on the input mode.
The CLOCK, PHASE, H-POS, and V-POS are automatically adjusted.
performs adjustment. Use this automatic adjustment when you use the D-SUB to display a PC screen for the
rst time or when you change the setting of the PC. (See page 28.)
SELF ADJUST (D-SUB)
On a D-SUB screen, specify whether to perform screen adjustment automatically or not.
When ON is selected, the screen is automatically adjusted when the timing of input signals changes.
For images with black edges, etc., depending on the signal, adjustment may not be possible. In this case select OFF. (Perform
manual adjustment of the screen.)
Adjusts frequency for sampling clock for applicable video.
Adjust when there is ickering in the form of vertical stripes.
When using the adjustment pattern (see page 28), make adjustments so that no vertical stripe noise appears in it.
Adjusts sampling clock phase for applicable video. Useful when small characters appear with low contrast and/or there are
ickers at corners. When using the adjustment pattern (see page 28), make adjustments so that no horizontal stripe noise
appears in it.
* Adjustments to PHASE should be made only after CLOCK has been correctly set.
Adjust the horizontal position of the image.
Adjust the vertical position of the image.
Changes the screen size. The screen size can also be changed using a remote control unit. (See page 19.)
Sets the image size and display area when SIZE is set to CUSTOM.
Enlarge and display part of the image.
Adjust the horizontal size of the image.
Adjust the vertical size of the image.
H-POS / V-POS (D-SUB)
Adjust the display position of the enlarged image.
INPUT RESOLUTION (D-SUB)
If a computer connected to the D-SUB output any of the following resolution, make a selection from the following options.
768......................AUTO, 1024x768, 1280x768, or 1360x768
1050....................AUTO, 1400x1050 or 1680x1050
1200....................AUTO, 1600x1200 or 1920x1200
Resets the values of the SCREEN menu items to the factory preset values.
Select “ON” and then press