Shure RK100PKW Car Amplifier User Manual


  Open as PDF
of 1
 
Model RK100PK and RK100PKW Microex®
Preampler Kit User Guide
27A3252 (Rev. 1) Printed in U.S.A.
©2007, Shure Incorporated
INSTALLATION - RK100PK (BLACK), RK100PKW (WHITE)
The RK100PK and RK100PKW preamp comes assembled for
use with microphones using a miniature 4-pin connector. To wire a
microphone cable directly to the preamp, follow these instructions:
Turn screw (A) counter-clockwise until it recedes below
the case.
Remove the cap (C) by removing the set screw (B) with
the provided hex wrench (.05 in.).
FIGURE 1
Push the circuit board out from the case interior to expose
the black and red wires (D).
Unsolder the wires from the circuit board (E).
FIGURE 2
1.
2.
3.
4.
Insert the rubber ex relief (G) into the cap (C) and feed
through the microphone cabling.
Note: You will need to reuse the rubber ex relief from your old
preamp. If the rubber ex relief is unavailable, please contact the
Shure Service Department.
FIGURE 3
Solder the wires directly back onto the circuit board.
Match wires as marked on the circuit board using the fol-
lowing key:
R = RED
B = BLACK
S = (GROUND) SHIELD
R
B
S
R
FIGURE 4
Push the circuit board back into the case, making sure
that the set screw (A) is lined up with the screw hole in
the side of the case (if the circuit board does not go in
all the way, twist it slightly until the screw and hole are
aligned). Raise the set screw (A) by turning clockwise
so that the preamplier is held securely in place. Screw
on the cap (C). Do not use the set screw with the cap.
5.
6.
7.
C
B
A
F
D
E
G
C
SHURE Incorporated http://www.shure.com
United States, Canada, Latin America, Caribbean:
5800 W. Touhy Avenue, Niles, IL 60714-4608, U.S.A.
Phone: 847-600-2000 U.S. Fax: 847-600-1212 Int’l Fax: 847-600-6446
Europe, Middle East, Africa:
Shure Europe GmbH, Phone: 49-7131-72140 Fax: 49-7131-721414
Asia, Pacific:
Shure Asia Limited, Phone: 852-2893-4290 Fax: 852-2893-4055