Filter
Top Products
[ Installation ]
11
Mounting the Radio
Attach the desired mounting device, dash or vent mount, to the vehicle docking station by
sliding the flat portion of the mount into the slot on the back top edge of the vehicle docking
station. Gently slide the mounting device in until it snaps into place.
Dash Mount Option (A)
If you choose the dash mount option, be sure to select your mounting position carefully. Once
the mount has been adhered to a surface, it will not be possible to remove it and adhere it
again.
Clean the selected mounting surface area in the vehicle with the alcohol swab. Unscrew the
adhesive foot from the mount. Peel the protective material off the adhesive on the foot and
press the foot firmly against the vehicle surface.
The adhesive mount should then be allowed to adhere for a minimum of 2-4 hours before use.
Best adhesion occurs after 24 hours.
Vent Mount Option (B)
To mount the vehicle dock using the vent mount option, install the vent mount as follows:
If the vent louvers in your vehicle are recessed, you may need to use the longer vent
hooks with the vent mount. Refer to Figure 2 and install the longer vent hooks into the
vent mount. Be sure to observe the orientation of the vent hooks as shown.
Slide Short
Vent Hooks Out
Remove
End Cap
Slide Extended
Vent Hooks In
Replace
End Cap
1.
Figure 2Figure 2