Filter
Top Products
SURROUND CENTER
–
+
2-899-202-11(2)
• To connect to speaker terminals (SURROUND, CENTER)
• To use the systems as surround speaker system
• To put the SS-CN3000P on your
TV set
Please attach a foot pad (supplied)
to each bottom corner of the
speaker, and make sure that the
speaker is completely flat on top of
the TV.
SS-CN3000P
Foot pads
• To hang SS-SR3000P with a hook
(not supplied) on the wall
You are responsible for the proper
selection and use of mounting
hardware that you purchase at
hardware stores, and for the proper
and safe mounting of the speakers.
• To install SS-SR3000P on the
speaker stand (not supplied)
It is recommended to use the optional
WS-FV11 or WS-FV10D speaker stand
(available only in certain countries).
Be sure to detach the screw A from
the speaker and use it during
installation. For details, refer to the
operating instructions supplied with
the speaker stand.
Hook
SS-CN3000P
Amplifier
SS-SR3000P
Speaker System
SS-CR3000
2007 Sony Corporation Printed in Malaysia
SS-SR3000P
(Right)
Precautions
• Avoid driving the speaker system continuously with a wattage exceeding the
maximum input power of this speaker system.
• Before connecting, turn off the amplifier to avoid damaging the speaker system.
• If the +/– connection is incorrect, the bass tones will seem to be missing and the
position of the instruments becomes obscure.
• The speaker grille on the SS-CN3000P and SS-SR3000P cannot be removed. Do
not attempt to remove the grille on the SS-CN3000P and SS-SR3000P. If you try
to remove it, you may damage the speaker.
In case color irregularity is observed on nearby TV screen
With the magnetically shielded type of the speaker system, the speakers can be
installed near a TV set. However color irregularity may still be observed on the TV
screen depending on the type of your TV set.
If color irregularity is observed...
→ Turn off the TV set, then turn it on after 15 to 30 minutes.
If color irregularity is observed again...
→ Place the speakers more apart from the TV set.
Specifications
SS-CN3000P (Center speaker)
Speaker system Full range, magnetically shielded
Speaker units 7.0 cm (2
3
/
4
in.), cone type × 2
Enclosure type Bass reflex
Rated impedance 8 ohms
Power handling capacity Maximum input power: 100 watts
Sensitivity level 85 dB (1 W, 1 m)
Frequency range 150 Hz - 20,000 Hz
Dimensions (w/h/d) Approx. 430 × 86 × 105 mm
(17 × 3
3
/
8
× 4
1
/
8
in.)
including front grill
Mass Approx. 1.6 kg (3 lb 9 oz)
Supplied accessories Speaker cord, short (1)
Foot Pads (4)
SS-SR3000P (Surround speakers)
Speaker system Full range
Speaker units 7.0 cm (2
3
/
4
in.), cone type
Enclosure type Bass reflex
Rated impedance 8 ohms
Power handling capacity Maximum input power: 100 watts
Sensitivity level 85 dB (1 W, 1 m)
Frequency range 150 Hz - 20,000 Hz
Dimensions (w/h/d) Approx. 110 × 170 × 111 mm
(4
3
/
8
× 6
5
/
8
× 4
3
/
8
in.)
including front grill
Mass Approx. 0.9 kg (1 lb 16 oz)
Supplied accessory Speaker cord, long (2)
Design and specifications are subject to change without notice.
English
SS-SR3000P
(Left)
Owner’s Record
The model and serial numbers are located on the rear of the unit. Record the
serial number in the space provided below. Refer to them whenever you call
upon your Sony dealer regarding this product.
Model No.
Serial No.
4.6 mm
10 mm
(2)
Screw A