Installation Instructions PSMH2682
5
ASSEMBLY AND INSTALLATION
Mount Installation
WARNING: IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! It is the installer’s
responsibility to make sure the structure to which this mount
is being attached can support a minimum of 2,000 lbs
(907.18kg). Reinforce the structure as required before
installing this mount.
1. Raise upper horizontal bracket (C) against wall in desired
installation location. (See Figure 1)
2. Level and adjust horizontal position making certain slots in
upper horizontal bracket on mount are properly positioned
over studs.
3. Using a pencil, or similar marking tool, mark the location of
mounting holes in base onto surface. (See Figure 1)
4. Hang two outside vertical brackets (A) from upper horizontal
bracket to determine mounting position for lower horizontal
bracket. (See Figure 1)
5. Raise lower horizontal bracket (C) against wall in desired
installation location using vertical brackets to determine
distance from upper horizontal bracket. (See Figure 1)
6. Mark the location of mounting holes for the lower horizontal
bracket in base onto surface. (See Figure 1)
7. Drill eight pilot holes at marked locations. (See Figure 1)
NOTE: Pilot hole size will depend on the type and size of
fastener being used.
Figure 1
8. Secure horizontal brackets (C) to studs using appropriate
hardware for mounting surface. (See Figure 2)
Figure 2
3
4
2
(A) x 2 (for reference, do not attach)
5
x 8
x 4
6
x 4
7
8
(C) x 2
