35
INSTALLER
KPL KEYPAD SETUP AND DIAGNOSTIC MENUS
KPL Setup Menu
The KPL Setup menu is used to
choose source names, check the
version number and perform a
Factory Initialization of the CAS44
controller. The menu is outlined in
the diagram at right.
To access the Setup Menu, press
and release the Setup button on the
right side of the keypad until
“SrcNm” (source names) appears on
the display. Press the Source button
to toggle through the menu options,
then press the Power button to enter
menus. Use the Volume Up/Down
buttons to scroll through the selec-
tions. Press the Power button to
enter a selection.
When finished, press and release the
Setup button again.
KPL Diagnostics Menu
The Diagnostics Menu allows the
installer to run a diagnostic check
on the keypad and to verify the
firmware version of the keypad.
To access the Diagnostics Menu,
press and hold the Setup button on
the right side of the keypad until
“Diags” appears on the display. The
menus are outlined in the diagram
at right.
When finished, press and release
the Setup button again.
