Filter
Top Products
Aiphone Communication Systems
1700 130th Ave. N.E.
Bellevue, WA 98005
(425) 455-0510
FAX (425) 455-0071
TOLL FREE TECHNICAL SUPPORT: (800) 692-0200
TOLL FREE FAX LINE: (800) 832-3765
E-MAIL: tech-serv@aiphone.com
KB-MV2 KB-MV3 Instr.
1105PHJS
Specifications:
Power Source: 6V DC at entrance panel. Use one SKK-620 per entry panel.
24V DC for tenant stations. Use one PS-2420UL per 2 monitors in each tenant’s location.
Operating Temperature: 14° ~ 140° F
Camera Unit: CCD (Charged Coupled Device)
Overall Viewing Area: 36" Vert. X 72" Horiz. At 20"
Video Monitor: 4" TFT LCD
Scanning Lines: 525 Lines
Call In From Door: 4-stroke chime from door #1, 2-stroke chime from door #2, fast 8-stroke
chime from door #3.
Communication: Hands free at entry panel, handset at tenant station(s).
Wire: 18AWG solid, non-shielded, PE insulation. Use Aiphone Wire # 871802.
Wiring Distance: 650' homerun from each entrance panel to each KB-3MRD master tenant station.
330' max. from KB-3MRD to last KB-3HRD in each tenant location.
Operation:
- Depress button at entry panel to activate chime, and video at tenant station.
- Upon receiving chime and video at tenant station lift handset to communicate to entry panel.
- To release door depress key button on tenant station.
- To tilt camera up or down, depress tilt button on tenant station.
- To view entrance panel when not called depress the monitor button.
- Entrance panel can only be viewed by one monitor at a time. If the entrance panel is occupied and another
tenant tries to monitor the entrance panel the monitor will not come on and a brief tone will be heard.
Technical Notes:
- If a specific directory is not lit up, that KB-3MRD master is either not connected or not powered on.
- If video times out immediately or does not come on at all, it is possible that the wrong type of wire was
used. Make sure cable is SOLID copper, non-shielded. Stranded wire cannot be used on this system.
- If the entrance panel looses 6V DC, the tenant that was last in communication with the door station, will
be the only one to receive a call no matter what button is depressed at the entrance panel.
WARRANTY
Aiphone warrants its products to be free from defects of material and workmanship under normal use and service
for a period of one year after delivery to the ultimate user and will repair free of charge or replace at no charge, should
it become defective upon which examination shall disclose to be defective and under warranty. Aiphone reserves unto
itself the sole right to make the final decision whether there is a defect in materials and/or workmanship; and whether or
not the product is within the warranty.
This warranty shall not apply to any Aiphone product that has been subjected to misuse, neglect, accident, or to
use in violation of instructions furnished, nor extended to units which have been repaired or altered outside of the
factory. This warranty covers bench repairs only, and any repairs must be made at the shop or place designated in
writing by Aiphone.
Aiphone will not be responsible for any costs incurred involving on-site service calls.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device , pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try and correct the
interference by one or more of the following measures:
— Reorient or locate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
FCC Class B Verification
NOTE:
Only wiring and information relating
to the installation of the KB-MV
series entrance panel is contained
here. Please consult the KB series
Installation & Operation Manual for
complete information on the KB
series equipment installed in each
tenant location.