Filter
Top Products
ENGLISH 7
En
PROGRAMMED PLAY
Up to 30 tracks can be programmed from the disc.
1 In stop mode, keep s STOP/MEMORY
pressed until “M” flashes in the display.
2 Press r, t to select a track, then
press s STOP/MEMORY to store it.
3 Repeat step 2 to program other tracks.
4 Keep s STOP/MEMORY pressed until
“M” stops flashing to finish the program.
“M” remains displayed and indicates the unit stores
the programmed tracks.
5 Press e to start play.
To check the program, press r or t in stop
mode.
To clear the program, press s once in stop mode so
that “M” disappears in the display.
To change the programmed tracks, clear the
program and repeat all the steps again.
Track number
Programmed number
Specifications
Tuner section
Frequency range, antenna — FM: 87.5 - 108.0 MHz
Rod antenna, AM: 530/531 - 1,710/1,602 kHz (10/9 kHz
step) Ferrite bar antenna
Deck section
Track format — 4 tracks, 2 channels / Frequency range
— Normal tape: 50 - 12,500 Hz (EIAJ) / Recording
system — AC bias / Erasing system — Magnet erase /
Heads — Recording/playback head (1), Erasure head
(1)
CD player section
Disc — Compact disc / Scanning method — Non-
contact optical scanner (semiconductor laser)
General
Speaker — 80 mm cone type (2) / Output —
Headphones jack (stereo mini-jack) / Power output —
2.5 W + 2.5 W (EIAJ 7 ohms, T.H.D. 10% DC) / Power
requirements — DC 12 V using eight size C (R14)
batteries, AC 120 V, 60 Hz / Power consumption —
18 W / Dimensions (W × H × D) — 310 × 171 × 260 mm
(12
1
/
4
× 6
3
/
4
× 10
1
/
4
in.) / Weight (excluding batteries)
— 2.8 kg (6 lbs. 3 oz.) / Accessory — AC cord (1)
Specifications and external appearance are subject to
change without notice.
COPYRIGHT
Please check the copyright laws relating to
recordings from disc, radio or external tape for the
country in which the machine is being used.
If an erroneous display or malfunction occurs
Make sure that none of the deck operation buttons is
pressed.
Press s while pressing POWER 6STANDBY.
If the unit cannot be reset in the way above, disconnect
the AC cord and remove all the batteries to turn off the
display.
Leave the unit for a while and turn the power back on.