Filter
Top Products
I
N
S
T
A
L
L
A
T
I
O
N
Before starting your installation we recommend to disconnect
the battery so there can be no damage done to the electrical system
of the vehicle. Before disconnecting the battery make sure that the
vehicles source unit does not have a password and if so you have the
password in hand to disable the security feature of the source unit.
Make sure your source unit (Cassette, CD, DAT, DVD, etc) is turned off
while connecting the terminals. Turn on the various components and
slowly advance the volume. Remember to check and recheck all con-
nections to insure proper use.
1. Alphasonik recommends using the wires that were supplied with
the the kit. Thinner gauge wire may easily be severed and can
cause damage to your system should any bare wire come in
contact with the vehicle’s chassis.
2. Make sure that your audio system is off while installing and con
necting your new Alphasonik enclosure. Failure to do so could
result in damaging the speaker beyond repair.
3. Be sure to route the wires to the amplier where it will be free
from sharp objects.
4. To insure long-term reliability, all bare wires and wire-to-wire
connections should be soldered and insulated with heat shrink
or electrician’s tape. Under no circumstances should you leave
any bare wires uncovered, as this can and will lead to the dam
age of your speakers.
5. Once you have tested your system and have conrmed that it is
operating properly, turn off your system and prepare for the nal
mounting.
6