Filter
Top Products
41-EN
Installation
• Stick the supplied cover sheet on the surface of the unit.
• The main unit must be mounted within 35 degrees of the horizontal
plane, back to front.
* If the installed mounting sleeve is loose in the main unit, the pressure
plates may be widened slightly to remedy the problem.
• For the screw marked “*
1
”, use an appropriate screw for the chosen
mounting location.
Removal
1. Remove the detachable front panel.
2. Insert the bracket keys into the unit, along the guides
on either side. The unit can now be removed from the
mounting sleeve.
3. Pull the unit out, keeping it unlocked as you do so.
Caution
Do not block the unit’s heat sink, thus preventing air circulation.
If blocked, heat will accumulate inside the unit and may cause a
fire.
Caution
When you install this unit in your boat, do not remove the
detachable front panel.
If the detachable front panel is removed during installation, you
might press too hard and warp the metal plate that holds it in
place.
Heat sink
Detachable
Front Panel
Cover sheet
Less than 35°
1
Remove mounting sleeve from the main unit (see
“Removal” on
page 41).
2
Reinforce the head unit with the metal mounting
strap (not supplied). Secure the ground to a wire
attached directly to the boat’s negative battery
terminal.
Connect each input lead coming from an amplifier or
equalizer to the corresponding output lead coming
from the left rear of the iDA-X100M. Connect all other
leads of the iDA-X100M according to details
described in the CONNECTIONS section.
3
Slide the iDA-X100M into the instrument panel until
it clicks. This ensures that the unit is properly
locked and will not accidentally come out from the
instrument panel. Install the detachable front panel.
Mounting Sleeve
(Included)
Instrument Panel
This unit
Pressure Plates*
Hex Nut (M5)
Screw
Bolt Stud
This unit
Ground Lead
Metal Mounting Strap
*
1
*
1
Battery
This unit
Bracket keys
(Included)
This unit