Filter
Top Products
4-EN
Basic Operation
Screen Display ON/OFF
1 Press the POWER button.
2 To turn off the POWER, press the POWER
button again.
• If properly connected, the monitors main
POWER will turn off when the vehicle's
ignition switch is off. If the main power lamp
illuminates in the STAND BY mode, the
vehicle's battery may be discharged.
• After turning the system off, a slight ghost of
the image will remain temporarily. This is an
effect peculiar to LCD technology and is
normal.
• Under cold temperature conditions, the
screen may lose contrast temporarily. After a
short warm-up period, it will return to normal.
Adjusting the Volume
1 Adjust the volume level by pressing the or
button.
Switching the Source
1 Press the SELECT button.
Each press of the button will cycle through the
modes as follows:
DISP
SELECT
POWER
NAV. (NAVIGATION)AUX1 AUX2
Main power
lamp
Switching the Screen Position
If the screen is out of position when, for example,
navigation system is connected to the AUX IN 1 or
AUX IN 2 terminal by using the RCA extension cable,
switch the screen position.
1 Switch the mode to AUX1 or AUX2 to display the
navigation screen.
2 Press and hold the DISP button for at least 2
seconds.
Press and hold the DISP button again for at least
2 seconds to return the position.