Filter
Top Products
17-EN
1 Parking brake lead (Yellow/Blue)
Connect this lead to the parking brake lead
powered when parking brake is pulled.
2 Monitor control lead (White/Pink)
Connect when upgrading with touch panel
compatible products such as the IVA-D300
series.
34
Remote control output lead (White/Brown)
To remote control input lead of ALPINE products
used in the system.
5 Reverse Lead (Orange/White)
Use only when a back-up camera is connected.
Connect to the plus side of the car’s reverse
lamp that lights when the transmission is shifted
into reverse (R).
Switches the video picture to the back-up
camera. This is linked with putting the car into
reverse (R).
6 ACC power lead (Red)
To ACC power lead powered when engine key
position is ACC.
7 Fuse (7.5A)
8 Ground lead (Black)
Connect the lead to a good chassis ground on
the vehicle. Make sure the connection is made to
bare metal and is securely fastened using the
sheet metal screw provided.
9 Brake Lamp
p Brake Connector (Included)
q Brake Signal Lead
w Brake Switch
e Headphone
r Main monitor
t Connection cable
y RGB cable
u To RGB output terminal
i Made by Alpine navigation
o Audio input connectors (AUX 1)
Use these connectors to input the audio signals
from a DVD player, video deck etc.
; Video input connector (AUX 1)
Use this connector to input the video signals
from a DVD player, video deck etc.
a Audio input connectors (AUX 2)
Use these connectors to input the audio signals
from a DVD player, video deck etc.
s Video input connectors (AUX 2)
Use this connector to input the video signals
from a DVD player, video deck etc.
d Audio output connectors
Use these connectors to output audio signals to
a rear monitor, etc.
f Video output connector
Use this connector to output video signals to a
rear monitor, etc.
To prevent external noise from entering the
audio system.
• Locate the unit and route the leads at least
10 cm away from the car harness.
• Keep the battery power leads as far away from
other leads as possible.
• Connect the ground lead securely to a bare
metal spot (remove the coating if necessary)
of the car chassis.
• If you add an optional noise suppressor,
connect it as far away from the unit as
possible. Your Alpine dealer carries various
Alpine noise suppressors, contact them for
further information.
• Your Alpine dealer knows best about noise
prevention measures so consult your dealer for
further information.
• When connecting to an IVA-D300 series or VPE-
S431, use the “AUX IN 1” connector. When
connecting a rear view camera, use the “AUX IN 2”.